Spindle Washer for Trailer Axle Spindle that is 1.06 inch in Diameter
Updated 10/27/2025 | Published 03/07/2025
Products Featured in This Question
Question:
I have a long boat trailer with 1.06 inch straight spindles. I ordered the new hun from you all and it seems to fit, but the old hub did not have a washer between the castle nut and outer bearing. I do not see a washer on the website for an ID of 1.06. What’s the best route to take?
asked by: Blake C
0
Expert Reply:
Hey Blake, while your spindle may have a diameter of 1.06 inch where the bearings ride the threaded portion would still be 1 inch so for a replacement spindle washer you'd need the part # SW1000.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- Bearing Kits
- Bearing L44649 and L68149
- Race L68111 and L44610
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Trailer Wiring Diagrams
- Q&A: Bearing Kit for 2017 Jayco Jay Flight 17BH
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Bearing Kit for Lippert 4,400 lb Trailer Axle
- Q&A: Replacement Bearing And Seals For UFP Hub H-1062-2
- Q&A: Replacement Hub/Rotor and Bearings for Tie Down Engineering TDE46245
- Q&A: What is the Best Grease for Trailer Bearings
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: How to Bleed Your Trailer Surge Brakes
Jameson C.
10/27/2025
Hey Blake, did the 1-inch spindle washer end up fitting your trailer hub the way you needed? Knowing how it worked could help others sorting out similar spindle size questions.