Q & A Icon

Replacement Hub for Adams Trailer with Dexter EZ Lube Axles with Bearings L44649

Question:

I have a drift boat trailer made by Adams Manufacturing in Shelley, ID I am replacing the hubs on both sides.... here is the relevant info I have The trailer, like all I have owned, have Dexter EZ lube axles mine is 5 on 4 1/2 bolt pattern Bearings are 44649 .......1 1/16 Inner seal is 1.249 Outer seal is 1.983 Can you tell me which hub assembly I need? I am looking to purchase hub assembly with seals, bearings already packed, with all hardware castle nut , tang washer or cotter pin, etc.

0

Expert Reply:

We have just the hub you are looking for with the part # AKIHUB-545-2-EZ-2K. This matches the bearing and seal info you listed, the bolt pattern, has an ez-lube cap for access to the grease fitting, and comes pre-greased so it's ready to install.

You will need new castle nut part # 165686, and then for standard cotter pin # 165649, for a tang washer part # 5-101, and for a D washer part # 5-23.

expert reply by:
0
Jameson C

Products Referenced in This Question





Product Page this Question was Asked From


Follow up Questions

Q & A Icon

Similar Expert Q&A Pages

See More Q&A Expert Answers >>