Recommended Custom Extendable Towing Mirrors for a 1999 Ford F-250

Question

Question:

I am looking at the CIPA CM47597 drivers side mirror for a replacement, but is there a passenger side CIPA replacement matching mirror also available? I would like both sides please.

asked by: Chuck J

0

Expert Reply:

Hey Chuck! For a 1999 Ford F-250 we only have the driver's side item # CM47597. I do have an alternate set though. It is the K-Source Custom Extendable Towing Mirrors item # KS61069-70F. These are custom fit for the 1999 Ford F-250 and have the same extension feature.

I have linked a diagram below that will show you the size of these mirrors. Feel free to leave a comment if you have any additional questions or concerns.

expert reply by: Jerred H

0

K-Source Custom Extendable Towing Mirrors
(click to enlarge)

Jerred H.

10/30/2025

Hey Chuck, how did the K-Source extendable towing mirrors work out on your F-250? Your update could make it easier for the next person looking for matching mirrors on both sides.

Answer 1

For wiring trailer brake assemblies we always recommend going with 10 gauge wire like part #10-1-1 which we sell by the foot. Even if the leads on the magnets are a smaller gauge it's best to go heavier for the wiring that goes from the trailer…

view full answer...

Answer 2

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The correct replacement driver's-side electric mirror for your truck is CIPA part #CM47597. Additional mirror functions such as heat cannot be added to a vehicle that was not manufactured with that function already in place. The wiring to support…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 12

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Recommended Custom Extendable Towing Mirrors for a 1999 Ford F-250

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching