Need Replacement Wiring Harness/Connectors For Ground Control Landing Gear
Updated 11/03/2025 | Published 12/30/2024 >
Question:
I have a Grand Design Reflection 5th wheel. I had a blow out on the passenger side rear wheel and it tore the wires up on the rear jack. My question is, do you have to buy thw whole harness or do you have the ends to splice the existing wires? See attached photos.
asked by: Kenny
Expert Reply:
Hey Kenny, thanks for reaching out, and sorry to hear about your blow out. The best solution here will be to buy a whole new harness part # LC307490. The ends of the connectors are not available separately, so a new harness will be the only way to get them. The # LC307490 mentioned above is intended for the front drivers-side, but if all you need is the connectors you could technically use it for the rear passenger side also.
Product Page this Question was Asked From
Replacement Wiring Harness for Lippert Ground Control 3.0 RV Landing Gear - Front Driver's Side
- Accessories and Parts
- Camper Jacks
- Wiring Harness
- Lippert
more information >
Continue Researching
- Q&A: Recommended Battery Monitoring Kit For RV Batteries
- Q&A: How To Test for Bad Controller on Lippert Ground Control 3.0 Electric Leveling System
- Q&A: Troubleshooting Error Message on Panel for Lippert Ground Control Leveling System
- Q&A: Troubleshooting Lippert Ground Control 3.0 Experiencing Retraction and Power Issues
- Article: How to Set the Right PSI for Your Air Bags
- Q&A: Troubleshooting A Ground Control 3.0 Leveling System That Won't Retract
- Q&A: Replacement Control Module For Lippert Ground Control 3.0 Leveling With 17410 Controller
- Q&A: Will Furrion Chill Cube Fit Ducted Setup Without Air Distribution Box
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Wiring Diagrams





Jesse M.
11/3/2025
Hey Kenny, how did things go with the replacement harness for your rear jack wiring? Your update could make it easier for the next person dealing with a similar repair.