Best Option For Replacing Damaged Monitor On Triple Vision M-70 Camera System

Updated 08/01/2025 | Published 07/28/2025

Products Featured in This Question

Rear View Safety Backup Camera System - 4 Camera Setup - Quad View Monitor

(40)

$855.24

Question:

I have a 2009 tiffin allegro open road 32la with a triple vision M-70 and it is intermittent screen. what do you have to replace this and what all does it include?

asked by: Ken C

Expert Reply:

Hello Ken, thanks for reaching out. I do have a solution for you, but we would not have a replacement monitor that will work with the current camera setup. Our best option for replacing it is to replace the entire camera system. For that I recommend the following:

- Rear View Safety Backup Camera System - 4 Camera Setup - Quad View Monitor # RVS-062710

This is a complete camera system. It comes with four cameras with a 120° viewing angle. It has a 7" color monitor. The monitor allows you to view each camera individually, or you can view all four at once. The cameras have IR night vision too. Overall it will be a nice upgrade from the current camera system.

I know replacing the whole system might not be your first choice, but that triple vision M-70 is an obsolete camera system so replacement parts just aren't available.

expert reply by: Jesse M

Ken

8/1/2025

Four cameras, so placement is normal where? I have kne on each side that turn kn with blinkers and one rear, will this system do the same with the blinkers? Where is the fourth normally mounted?

Jesse M.

8/1/2025

@Ken It really depends on your specific camper but typically the camera brackets will go close to the rear marker lights to make wiring easier. You can wire the side cameras to the turn signal circuit. The instructions on the part page show some typical installation locations.