Mounting Hardware For The OptiMate Solar Duo Roof Mount Solar Charging System # MA29JR

Question

Question:

Do you carry the mounting hardware for this charger?

asked by: Robert J

0

Expert Reply:

Hey Robert,

The OptiMate Solar Duo Roof Mount Solar Charging System with Controller # MA29JR doesn't have specific mounting hardware because they don't know exactly what you're going to be mounting the panel to. If mounting to the roof of an RV you could use self-tapping screws through the four mounting holes in the corners of the panel. If mounting to the roof of your vehicle you could use t-bolts and slot them into crossbars or platform rack.

What are you wanting to mount the panel to?

expert reply by: Kevin C

0

Jerred H.

11/17/2025

Hey Robert, what did you end up using to mount the OptiMate Solar Duo panel? Your setup details could really help others figuring out how to secure theirs.

Answer 1

A lead acid battery will typically discharge anywhere from 3% to 20% in a month's time and will typically have a higher discharge rate during cold weather. The wattage size needed to keep your batteries charged will depend on how large of an amp…

view full answer...

Answer 2

What I think you are asking is how to determine the minimum amount of energy, by way of solar panels, that you need to have available to put back in to your battery. If your goal is to simply maintain the battery while the RV is in storage unable to…

view full answer...

Answer 3

At the end of the day, you can use any of those options (stainless steel, zinc or chrome), you just need to get a lug nut that fits the 9/16 stud. But, we do not have a chrome option that fits the 9/16 stud. Personally, I would go with the stainless…

view full answer...

Answer 4

There should be no issues converting from your current setup to a wheel and tire like the #TA69VR Provider 215/75R17.5 Radial Tire w/ 17-1/2" Solid Center Wheel. The wheel will match your current bolt pattern and, assuming you have ST235/85R16…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Mounting Hardware For The OptiMate Solar Duo Roof Mount Solar Charging System # MA29JR

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching