OptiMate Solar Duo Roof Mount Solar Charging System with Controller Review Video

The coupler lock I recommend for your UFP A-60 Coupler is the Coupler Lock, part #e98888. Since the coupler measures 3-inches wide and the pin hole is 1/4 inch diameter the #28012 will work great to secure the coupler. The lock has a covered key slot…

You are correct. The #BDW20351 comes with 4 padded axle strap covers for paint protection while the #BWD20350 does not. Otherwise these strap kits are identical. Since you are planning to use this 2019 Corvette Grand Sport I would definitely choose…

Hey Greg, thanks for reaching out to us! Hopefully I can help you get all of this figured out so you can seamlessly keep your refrigerator battery charged up. It sounds like you're needing the Redarc In-Vehicle BCDC Trailer Battery Charger…

Mike, no the Redarc In-Vehicle BCDC Trailer Battery Charger #RED36TR does not come with a solar panel. This can be used with a solar panel though - you'd just need to connect the power wire on the solar panel to the yellow wire on the BCDC…

Hey Kevin, so the Redarc 12V Smart Battery Monitor #RED42RR can only be used with a single 12 volt battery. It can not be used with a two battery bank that has 6 volt batteries.

Yes, according to Redarc the #RED42RR will work with multiple batteries. It will be compatible with your 2 AGM batteries wired in parallel as long as you aren't over 500 Ah.

Yes, the Redarc 12V Smart Battery Monitor #RED42RR will work with your 450 Ah setup from your four 6V batteries. I have attached a wiring diagram below for your reference.

The Redarc BCDC Charger part #RED36TR can work with your fridge but it wasn't designed to power accessories directly. You could use it to charge your 12 volt battery that is then powering your 3-way fridge on DC mode though.

There are 4 mounting holes on grab handle #PLR817-SS; 2 on each end. The holes on each end are spaced 1 inch apart on center. The top-most hole to the bottom most hole is 12 inches apart on center. And the other two holes are spaced 10 inches apart…

Given that trailer wiring only consists of basic light functions, 12 volt power, and brake output a system of fuses is not necessary because it is easy to determine if something is not working. If there was a short, the way you would know with or…

The Assist Handle #PLR817-SS that you referenced is made from solid stainless steel. I attached a review video link for this for you to check out as well.

On the Pollak 7-Circuit-Breaker Junction Box, #PK52249, the bar inside is just a mounting bracket for circuit breakers. You would connect power as needed to each circuit breaker. The bar was also designed to dissipate excess heat generated from the…