Does etrailer Tonneau Cover for 2025 GMC Sierra with Multipro Tailgate

Question

Question:

Will this fit the multifunction tailgate makes into a step on the 2025 GMC Sierra Denali 1500?

asked by: Fred L

0

Expert Reply:

Hey Fred, yes the etrailer tonneau cover part # e23DR does fit your 2025 GMC Sierra 1500 with the MultiPro tailgate.

expert reply by: Jameson C

0

Jameson C.

11/17/2025

Hey Fred, how did the fit of the etrailer hard tonneau cover work out with your Sierra’s MultiPro tailgate step? Knowing how it functions with that setup could help others looking at the same cover.

Answer 1

Hi Mark, I see you went with the B&W Patriot—fantastic choice! Given that you have a 5 3/4' bed, I’d recommend a roll-up cover like the TruXedo TruXport Soft Roll-Up Tonneau Cover #TX272401. Unlike a folding cover, a roll-up design takes up…

view full answer...

Answer 2

Hey Dave, yes the etrailer tonneau cover part #e23DR does fit your 2025 Chevy Silverado with a spray in bed liner and a multi-flex tailgate.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 6

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Does etrailer Tonneau Cover for 2025 GMC Sierra with Multipro Tailgate

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching