Does etrailer Tailgate # e23DR Fit 2025 Chevy Silverado with a Spray in Bedliner

Question

Question:

etrailer Hard Tonneau Cover - Folding - Fiberglass Reinforced Plastic - Matte Black does this fit the 2025 Silverado 1500 with the spray on bed liner installed and multi-flex tailgate?

asked by: Dave W

0

Expert Reply:

Hey Dave, yes the etrailer tonneau cover part # e23DR does fit your 2025 Chevy Silverado with a spray in bed liner and a multi-flex tailgate.

expert reply by: Jameson C

0

Dave W.

6/25/2025

Thanks for the prompt response, appreciated

Jameson C.

6/25/2025

@DaveW No prob! Glad to help!

Answer 1

Hi Mark, I see you went with the B&W Patriot—fantastic choice! Given that you have a 5 3/4' bed, I’d recommend a roll-up cover like the TruXedo TruXport Soft Roll-Up Tonneau Cover #TX272401. Unlike a folding cover, a roll-up design takes up…

view full answer...

Answer 2

Hey Fred, yes the etrailer tonneau cover part #e23DR does fit your 2025 GMC Sierra 1500 with the MultiPro tailgate.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Does etrailer Tailgate # e23DR Fit 2025 Chevy Silverado with a Spray in Bedliner

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching