Easy to Use Snow Plow Recommendation for 2006 Jeep Liberty

Question

Question:

I have a 2006 V6 Jeep Liberty 4WD that I thought I could use to plow my 576foot straight driveway. Up to now Ive used a Artic Cat 4WD Quad but at age 90 I need something else. I would like all the items I need to mount your plow to my Jeep, the easy simplest way. Thank you

asked by: James H

0

Expert Reply:

Hey James, the overall simplest solution is the Snowsport plow part # SS98GV which you'd mount in the front hitch part # C31022 that fits your 2006 Jeep Liberty. There's no wiring or winches to deal with so it's simple but it does require getting out and lifting the winch off the mount when you want to use it so it's not the easiest overall.

If you wanted something easier to control once installed you'd want the SnowBear Plow part # K2AVAL8219 which can raise and lower with an in-cab remote and also installs in the same Curt front hitch # C31022.

expert reply by: Jameson C

0

James H.

12/16/2024

Hi Jameson C thanks for the reply Question I see that this plow comes in 3000 lb chain lift instead of nylon strap, do you sell and how much

Jameson C.

12/16/2024

@JamesH The part # K2AVAL8219 I mentioned actually has a chain lift and a winch lift capacity of 3,000 lb like you asked about. Were you thinking of something different?

Answer 1

Hey James it sounds like you are asking if there is a way to attach a plow setup to the base plate kit you have installed on your truck currently which the answer to that would be no. You'd need to go with plow mounts instead like the Detail part…

view full answer...

Answer 2

As shown in the provided photo, the receiver tube of the Curt #C31022 front mounted receiver will be located just under the front bumper and would be a good fit for your 2005 Jeep Liberty. If you click the provided link, you an see the installation…

view full answer...

Answer 3

Thank you for your picture. Yes, the Detail K2 Plow part #K2RAMP8219 can be used on your 1994 Jeep YJ Wrangler with the custom bracket kit that fits your vehicle with the part #K284115.

view full answer...

Answer 4

The installation of CURT Front Hitch, part #C31022, to your 2003 Jeep Liberty, will require a couple of holes to be drilled on the vehicles frame. If you have a front air dam it will have to be permanently removed from the vehicle. I am including a…

view full answer...

Answer 5

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 6

Hi Stan! The SnowBear Snowplow for 2" Hitches - 82" Wide x 19" Tall #K2AVAL8219 and Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2" #C31018 will definitely work on your 2013 Ford F-250 4x4. We actually have both of these…

view full answer...

Answer 7

Hey Dean, the Detail K2 Elite Snowplow part #K2AVAL8219ELT that you referenced comes with all of the electrical components it will need to install. It wires to the vehicle battery as well as comes with a wired switch that you would run to the cab of…

view full answer...

Easy to Use Snow Plow Recommendation for 2006 Jeep Liberty

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching