Stake Pocket D-Ring Tie Down For Non-Standard 2-5/8"x1-9/16" Stake Pocket Hole

Question

Question:

Do you have any stake pocket d-ring tie downs that will fit a 2 5/8 x 1 9/16 pocket? I have a carry-on trailer that has these odd ball size pockets. I need one that will be 2.5 x 1.5. Thank you.

asked by: John D

0

Expert Reply:

Hello John. Most of the stake pocket tie-down anchors we offer are for the standard 2"x4" stake pocket opening. The only option I can think of are the CargoSmart Stake Pocket Tie-Down Anchors # 348821. These are universal D-rings that can be used in most any stake pocket opening, standard or non-standard. They are super easy to add on, you just insert the end with the "wings" and then screw it in to tighten. The safe working load limit is 200 lbs so you do need to be careful not to overload them.

expert reply by: Jesse M

0

Jesse M.

1/12/2026

Hey John, how did those CargoSmart stake pocket tie-down anchors work out on your Carry-On trailer? It’d be great to know if they fit your 2 5/8 x 1 9/16 pockets as hoped. Your update could make it easier for others with non-standard pocket sizes.

Answer 1

Hey Kaison, I attached a picture to this page that has every relevant dimension of the Stake Pocket Tie-Down Anchor #WFSPDR for you to check out. Check them out and let me know if this will work for you. The listed dimensions are for sure accurate as…

view full answer...

Answer 2

Hey Lynn, you could potentially use the tie down anchors part #WFSPDR in a 6 inch deep stake pocket. It really would come down to how far down into the stake pocket the pin hole is that you would use to secure it. This one has 3-1/4 inches from the…

view full answer...

Answer 3

Hello David, thanks for reaching out. The difference between the Brophy Stake Pocket Tie Down Anchors #TL1B and #TL2B is the D-ring size. The #TL1B has a 2-5/16" D-ring, while the #TL2B has a 3" D-ring. I have included a drawing with the…

view full answer...

Answer 4

Yes. I went ahead and reached out to my tech at Brophy, and he said that as long as you are within the weight capacity of the Brophy Stake Pocket Tie-Down Anchor #TL1B, you can use chains/ratchet binders. It is important to note that each tie-down…

view full answer...

Answer 5

Hey Bob, I went out to the warehouse and measured the Brophy Stake Pocket Tie Down Anchor #TL1B and unfortunately think this one is going to be a bit too long for you. From the bottom of the tie down to the underside of the flange measures 8", 3…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Stake Pocket D-Ring Tie Down For Non-Standard 2-5/8"x1-9/16" Stake Pocket Hole

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching