Could Stake Pocket Tie-Down Anchor # WFSPDR Fit 6 inch Stake Pocket

Question

Question:

Do you sell tie down anchors that fit a six inch deep stake pocket

asked by: Lynn L

0

Expert Reply:

Hey Lynn, you could potentially use the tie down anchors part # WFSPDR in a 6 inch deep stake pocket. It really would come down to how far down into the stake pocket the pin hole is that you would use to secure it. This one has 3-1/4 inches from the top of the stake pocket down to the hole for example.

expert reply by: Jameson C

0

Dimensions
(click to enlarge)

Lynn L.

6/18/2026

The 5 3/8 measurement in photo would need to be greater than 6 inches probably closer to 7

Jameson C.

6/18/2026

@LynnL I think we have just what you are looking for with the part # TL2B which is 6-3/4 inches from the top of the anchor down to the pin that holds it in place.

Answer 1

Hey Kaison, I attached a picture to this page that has every relevant dimension of the Stake Pocket Tie-Down Anchor #WFSPDR for you to check out. Check them out and let me know if this will work for you. The listed dimensions are for sure accurate as…

view full answer...

Answer 2

Hello John. Most of the stake pocket tie-down anchors we offer are for the standard 2"x4" stake pocket opening. The only option I can think of are the CargoSmart Stake Pocket Tie-Down Anchors #348821. These are universal D-rings that can be…

view full answer...

Answer 3

No, they do not Ronald. The Maxxis item #MXS77FR you were looking at, includes a pre-mounted load range E ST225/75R15 tire with valve stem on a 15" diameter x 6" wide rim with a 6 x 5-1/2" lug nut pattern. I've attached a picture…

view full answer...

Answer 4

Hey John! The Furrion Vision S+ #FR57AD does act as sort of a rear view mirror when you're towing or if you have an in bed camper, but it is not designed to replace the mirror on your vehicle. The camera stays on while you’re driving so you can…

view full answer...

Answer 5

Hey Mark, yes we do have a version of the Andersen part #AN88VR with a 2-5/16 inch ball instead with the part #AN53VR. What does your trailer weigh?

view full answer...

Answer 6

Hi Darryl, These jacks are exactly the same dimensions, but the difference is the the Square 2-Speed Jack - Drop Leg w/ Spring Return - Sidewind - 25-7/8" Lift - 10K #e79FV has the drop leg plunger on the front of the jack while the Square…

view full answer...

Answer 7

It sounds like your weight distribution system is most likely rated properly but the sway you are experiencing is not something that a WD system would be effective at eliminating. Also worth noting is you said it's an aluminum trailer which is…

view full answer...

Answer 8

Hi Shawn! The mounting holes on the Demco Trailer Coupler - Cast - Adjustable Channel #DM14040-81 measure 2" on center (which I included a quick diagram of). It is typically used with something like the 6-Hole Adjustable Channel Bracket - Weld…

view full answer...

Could Stake Pocket Tie-Down Anchor # WFSPDR Fit 6 inch Stake Pocket

Product Page this Question was Asked From

Continue Researching