Can 15 inch by 5 inch Width Trailer Wheel get Replaced with 6 inch Wide Wheel

Question

Question:

My trailer originally has 15x5 wheels. I understand this wheel is an inch wider. Will it still work?

asked by: Darrell K

0

Expert Reply:

Hey Darrel, unless your trailer had some super tight clearances you would have no issues going from the 5 inch width of your current wheels to the 6 inch width of the part # AM20504 that you referenced. You need to have at least one inch between the trailer frame and the wheel and this wider wheel would take up an additional 1/2 inch.

expert reply by: Jameson C

0

Jameson C.

1/27/2026

Hey Darrel, how did the fit turn out with the 15x6 Dexstar wheel on your trailer? It’d be great to know if the extra width still gave you enough clearance. Your update could make it easier for the next person checking wheel sizes.

Answer 1

To determine if the a wider and taller wheel will work on your trailer you'll need to do a bit of measuring. You'll measure horizontally from the wheel over to the frame and then vertically from the wheel up to the fenders to make sure…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Can 15 inch by 5 inch Width Trailer Wheel get Replaced with 6 inch Wide Wheel

Product Page this Question was Asked From

Continue Researching