Is There A Hub/Drum Assembly That Uses The Same Bearings And Seals As The Dexter DX22XR
Updated 01/27/2026 | Published 08/14/2024
Question:
I am looking at your Dexter DX22XR hub. Do you have a brake drum with the same bearing and seal ID?
asked by: Kevin C
0
Expert Reply:
Hey Kevin,
The Dexter Trailer Idler Hub Assembly # DX22XR unfortunately uses uncommon bearings so there isn't a compatible hub/drum replacement available at this time. The only option we could offer would be to replace the axle with a one that has a more common spindle. If you want to go that route then let me know and I'd be happy to help.
expert reply by:
Kevin C
0
Product Page this Question was Asked From
Dexter Trailer Idler Hub Assembly for 2,500-lb Axles - 5 on 4-1/2
- Trailer Hubs and Drums
- Idler Hub
- Standard
- LM67048 / LM11949
- Standard Grade
- For 2500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- Dexter
more information >
Continue Researching
- Shop: Dexter Trailer Idler Hub Assembly for 2,500-lb Axles - 5 on 4-1/2
- Q&A: Availability Of Trailer Hub With .75" Outer And 1.25" Inner Bearings
- Q&A: Looking For Replacement Trailer Hubs For 5 on 4-1/2" Lug Pattern With LM11949 Bearing And LM11910 Ra
- Q&A: 5 on 4-1/2" Idler Trailer Hub For Utility Trailer With 1-1/4" to 3/4" Tapered Spindle
- Q&A: Hub and Drum Assembly for 1 1/4 inch by 3/4 inch Axle
- Shop: Trailer Idler Hub Assembly for 2,000-lb Axles - 4 on 4 - Galvanized
- Shop: Dexter Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2
- Shop: Trailer Hub Assembly - 3,000 lbs Axles - 4 on 5 - Agricultural
- Q&A: How do I Find Out Which Hubs Fit My Trailer's Spindles
- Shop: Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-1/2 - Galvanized
- Q&A: How to Measure to Determine the Correct Grease Seal for a Trailer Spindle
- Q&A: How to Confirm Correct Size of Grease Seal
- Shop: Spindle Grease Seal Set for LM67048 Inner Bearing and 2.328 Bearing Buddy
- Shop: Trailer Axle with Idler Hubs - 4" Drop - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs
Gwendolyn Y.
1/27/2026
Hey Kevin, did you decide to look into replacing the axle so you could use a hub and drum setup with more common bearings? Knowing what direction you went could help others facing the same issue.