How Much Brake Fluid For Demco Kar Kaddy SS Tow Dolly

Question

Question:

How much brake fluid should I purchase for the Kar Kaddy SS first time fill?

asked by: BILLY J

0

Expert Reply:

Hi Billy,

For the Demco Kar Kaddy SS Tow Dolly # DM9713045, go with 500 ml of brake fluid. Also be sure it's DOT-3 or DOT-4 brake fluid, per the instructions.

expert reply by: Kyle S

0

Robin H.

2/3/2026

Hey Billy, how did the 500 ml of brake fluid work out for your Kar Kaddy SS? Sharing what you found could help others getting ready for their first fill too.

Answer 1

Hello David, thanks for reaching out. The bearings for the Demco Kar Kaddy SS Tow Dolly #DM9713045 are sealed. So you cannot repack them. If the hubs are in need of replacement, you will need to replace the entire hub assembly with part #DM04369.…

view full answer...

Answer 2

I have attached an image from the operation manual for the Demco Hydraulic Brake Actuator #DM8669112 that details how to bleed the brakes. The process consists of first elevating the trailer tongue about 4 to 6 inches and then loosening or removing…

view full answer...

Answer 3

You can test that the hydraulic brakes on your Demco Kar Kaddy SS Tow Dolly #DM9713045 are working correctly by jacking up one wheel and chocking the other. Have a friend use a piece of wood to engage the surge brake actuator while you try to spin…

view full answer...

Answer 4

If the steering stabilizer shock on your Demco Kar Kaddy SS Tow Dolly part #DM9713045 has gone bad then the wheels on the tow dolly may shimmy a bit while driving down the road or you will see oil around where the shock mounts as this would point to…

view full answer...

Answer 5

Replacement Steering Stabilizer Shock #DM01729-30 is the correct current replacement part for your Kar Kaddy 3 and it also fits the Kar Kaddy SS model tow dolly. I verified this item in Demco's Kar Kaddy specs.

view full answer...

Answer 6

As a matter of fact we do. I spoke with a representative of Demco who told me that the Replacement Steering Stabilizer Shock for Demco Kar Kaddy #DM01729-30 will work with the Kar Kaddy 2.

view full answer...

Answer 7

I have attached a video for you to help you bleed the surge brakes and also given an explanation below. You want to top off the master cylinder and pump the fluid from the master cylinder. You can do this by unbolting the plate that holds the lever…

view full answer...

Answer 8

We've got the owner's manual for the Demco Kar Kaddy SS Tow Dolly with Disc Brakes #DM9713045 linked just below as "Instructions for DM9713045".

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

How Much Brake Fluid For Demco Kar Kaddy SS Tow Dolly

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching