Can I Install An Aftermarket Hitch On A 2010 Toyota Tacoma With Factory Installed Hitch?
Updated 02/17/2026 | Published 06/12/2024
Question:
I am looking for a class III hitch for a 2010 Tacoma that I just bought. I believe the rusted hitch that is on it probably came from the factory. The hits that come up on your website all say the hitches will not fit if I have a factory hitch. What makes them not fit, and is there a reasonable alternative that I am just not seeing? Thanks. Denny Smith
asked by: Denny S
Expert Reply:
Hello Denny, great question. It is possible to install our etrailer Class 3 Hitch # e98850 on a 2010 Toyota Tacoma with the factory installed hitch. According to my research, the factory hitch mounts using the bumper brackets. So, if you remove the factory hitch you will need to find brackets for the bumper. Once you do this you can install the etrailer Class 3 Hitch # e98850.
Product Page this Question was Asked From
etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 5500 lbs WD GTW
- 2 Inch Hitch
- 550 lbs WD TW
- Concealed Cross Tube
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Hitch
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Q&A: Width of etrailer Trailer Hitch for 2005 Toyota Tacoma
- Q&A: How Should I Wire My Batteries in Parallel While Using the Victron SmartShunt Battery Monitor?
- Q&A: Recommended Trailer Hitch For A 2005 Toyota Tacoma
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacing Factory Hitch on 2013 Toyota Tacoma
- Q&A: Can 2013 Toyota Tacoma OEM Trailer Hitch Be Replaced with Aftermarket Trailer Hitch
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Ball Mount for 2 Inch Ball with No Rise and No Drop
- Q&A: Converting Trailer from 5-Way Connector to a 7-Way by Function
- Article: How Much Does a Boat and Trailer Weigh?
- Article: Trailer Wiring Diagrams
- Article: What Do I Need To Tow A Trailer?
- Article: Trailer Hitch Installation Tips
Jesse M.
2/17/2026
Hey Denny, how did things go with the etrailer Class 3 hitch on your Tacoma after removing the factory one? Were you able to find the right bumper brackets and get everything mounted securely? Your update could make it easier for others working with the same setup.