Recommended Replacement For A Dometic DOTRC11B RV Microwave

Question

Question:

I have a Dometic DOTRC11B Microwave that needs replacing. What is the best replacement ?

asked by: Robert

0

Expert Reply:

Hey Robert,

The Dometic DOTRC11B is showing as 29-7/8" wide x 14" tall x 18-3/16" deep so the closest fit would be the Greystone Over the Range RV Microwave # 324-000135. This microwave is 29-7/8" wide x 16-7/8" tall x 18-3/16" deep so it is going to be slightly taller. It has a 950 watt output compared to your current unit's 850w output and a 1.6cu/ft interior compared to your current 1.1cu/ft interior.

expert reply by: Kevin C

0

Answer 1

Hello Glen, The Replacement Step Control Module for Lippert Tread Lite Powered RV Steps #LC334850 is a replacement control module specifically designed for Lippert Tread Lite electric RV steps. There is no “brake control motor” in the step system.…

view full answer...

Answer 2

The Stromberg Carlson RV Exterior Ladder #LA-401 should work for you, but it would not use the same installation points, this is a universal ladder that will require you to drill different installation points.

view full answer...

Answer 3

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 4

The replacement motor you need is the #LC183058 for the Lippert Tread Lite steps #LC353543 that you referenced. It could be the sensors on the door of your RV that's either failed or fallen off. You might check there to verify that the magnets…

view full answer...

Answer 5

I reached out to my contact at Jensen and he did say that your AWM975 model stereo has been out of production for a while. To replace the unit he said the best option is with the Jensen RV Stereo #JWM60A, which features the same cutout size and…

view full answer...

Answer 6

In order to replace the Bargman L-200 Door Lock Set, I recommend taking a look at the Global Link RV Entry Door Locking Latch Kit part #295-000019 for black, part #295-000021 for white, or part #295-000002 for chrome. This system has a sturdy steel…

view full answer...

Answer 7

The best option we have for you is the Double Lip Grease Seal part #34823 which measures 1.249" inner diameter x 1.983" outer diameter and is commonly used with the Trailer Wheel Bearing part #L44643. The dimensions are close enough to…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Recommended Replacement For A Dometic DOTRC11B RV Microwave

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching