Replacement Ladder Recommendation for a 2005 Four Winds Chateau

Question

Question:

Need to replace the exterior ladder on a 2005 Four Winds Chateau 29foot photo attached. Will the replacement be able to use the same screw holes to attach?

asked by: Lew K

0

Expert Reply:

The Stromberg Carlson RV Exterior Ladder # LA-401 should work for you, but it would not use the same installation points, this is a universal ladder that will require you to drill different installation points.

expert reply by: Jameson C

0

Answer 1

Hello Glen, The Replacement Step Control Module for Lippert Tread Lite Powered RV Steps #LC334850 is a replacement control module specifically designed for Lippert Tread Lite electric RV steps. There is no “brake control motor” in the step system.…

view full answer...

Answer 2

Hiya Marty. While I wish I could look up exactly what your 2001 Damon Intruder 375 came with I have no access to a parts lookup from the manufacturer. Based on images and videos I found it looks like the Global Link RV Baggage Door Slam Latch…

view full answer...

Answer 3

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 4

Hey Derek, sorry about the ladder! Those trees will jump out of nowhere. For a replacement though I would need to know what the length of your current one is roughly so that we can match it to the nearest universal ladder replacement we have. For…

view full answer...

Answer 5

Hey Robert, The Dometic DOTRC11B is showing as 29-7/8" wide x 14" tall x 18-3/16" deep so the closest fit would be the Greystone Over the Range RV Microwave #324-000135. This microwave is 29-7/8" wide x 16-7/8" tall x…

view full answer...

Answer 6

The replacement motor you need is the #LC183058 for the Lippert Tread Lite steps #LC353543 that you referenced. It could be the sensors on the door of your RV that's either failed or fallen off. You might check there to verify that the magnets…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hi Donny; after looking at several videos of the trailer it does appear to have a 6 on 5-1/2 bolt pattern with ST225/75R15 tires. The Goodyear Endurance ST225/75R15 Radial Tire w/ 15" Eagle Aluminum Wheel #GY97QB will be a direct fit.

view full answer...

Answer 11

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Replacement Ladder Recommendation for a 2005 Four Winds Chateau

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching