Air Bag Suspension Enhancement Kit that Fits 2019 Winnebago Class A F-53 Chassis

Question

Question:

Hi I need help with rear air bags for a 2019 winnebago class A with a f53 chassis, 30 foot thanks

asked by: David S

0

Expert Reply:

Hey David, so we have the Air Lift kit part # AL57344 that fits your 2019 Winnebago Class A motorhome that is built on a F-53 chassis. This fits as long as the GVWR is NOT 24 or 26k so you would need to verify that. This is only option we have though.

expert reply by: Jameson C

0

Dave S.

6/6/2024

Thanks Jameson c mine says 18000 , 7000 front , 12000 rear , so hopefully these will work , thanks

Reply

Jameson C.

6/6/2024

@DaveS Yep they will!

Reply

Answer 1

Hey Micah! Pacbrake has actually been around for a long time, more than 60 years. We have had customers ask for these air bags in the past, and we've seen them on vehicles coming in. Until now, Firestone has been the go to since their quality is…

view full answer...

Answer 2

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

Hey Jeff, I checked with Firestone and the only version of the 2025 Toyota Tacoma that the part #F83VV doesn't fit is the 2 wheel drive models. The SR5 can be either 4wd or 2wd so you would need to verify which configuration you have to know if…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Air Bag Suspension Enhancement Kit that Fits 2019 Winnebago Class A F-53 Chassis

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching