Recommended Rear Camper Tie-Downs For A 2012 Ram 3500 With TorkLift SuperHitch Original # TLD1102

Question

Question:

I just installed the TDL 1102 Super hitch on my 2012 Ram 3500 HD. I had to remove the rear frame mount camper tie down. What is the correct P/N for the rear camper tie down to use with the factory hitch and and super combination for my truck.

asked by: James H

0

Expert Reply:

Hey James,

The correct rear camper tie-downs to go along with your new TorkLift SuperHitch Original Trailer Hitch Receiver # TLD1102 are going to be part # TLR3505. These will mount directly to the hitch at the end of the crosstube.

expert reply by: Kevin C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

Hello Ken, thanks for reaching out. Sounds like you are on the right track here because the type of running boards on your truck do dictate which tie downs to use. You are also correct that you will not be able to use the tie downs from your old 2002…

view full answer...

Answer 9

Hey Jim welcome back. To determine if you need the TorkLift Camper Anchor Relocation Kit item #TLA7004, you'll have to take a measurement. You'll want to measure from the front bumper of your Palomino HS2902 to the center of the rear anchor…

view full answer...

Answer 10

Hey John, congrats on the new truck. Yes, the Brophy Slide In Camper Tie-Downs - Extra Clearance item #HSAB can be used with your 2026 Ram 3500 dually. What turnbuckles did you use previously with your 2021 Lance 865?

view full answer...

Recommended Rear Camper Tie-Downs For A 2012 Ram 3500 With TorkLift SuperHitch Original # TLD1102

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching