What is The Additional Power Cable Connector For On The Furrion Monitor Power Cable?

Question

Question:

What can be used with auxiliary cable? Can it be used with a plug in style power cord?

asked by: Diana

0

Expert Reply:

I believe you are referring to the additional connector on the Replacement Furrion Monitor Power Cable # C-FOS07TAPK-006 as that is all I can see you looked at. This connector allows you to plug in the Camera # FCN48TASF so that you can pair it to the Monitor # FR47FR without having to have a 2nd person. Then you can install the camera on the back of the RV/Trailer after it is already paired to the monitor.

expert reply by: Bud M

0

Answer 1

Hi Tim; I reached out to Go Power and their representative told me the flashing on the Go Power Sun Cycle Advanced Lithium RV Battery #GP99QR meant it is in sleep mode, so the "battery charge path is enabled but discharge path is disabled and…

view full answer...

Answer 2

Hey Kevin, thanks for reaching out again! The TorkLift SuperTruss Hitch Extension for SuperHitch Trailer Hitch Receivers #TLE1542 measure 42" from the center of on hitch pin hole to the center of the other hitch pin hole. I've attached an…

view full answer...

Answer 3

Hey Mike, it is important that you use the included power cable with the Furrion Vision S+ Wireless RV Backup System w/ 1 Camera #FR57AD like the instructions indicate. If this is like a hardwire install I would look for a cigarette lighter to 2-wire…

view full answer...

Answer 4

I checked with Furrion and the 7 inch and 5 inch monitor version of the Furrion observation system #FOS05TASF use part #FR79SR. The smaller 4.3 inch size use the part #LC776462. The ball of the #FR79SR is 0.85" or 21.59mm and the ball of the…

view full answer...

Answer 5

The diameter of the ball on the Replacement Suction Cup Mount for Furrion Vision S 5" and 7" Monitors #FR79SR is .85".

view full answer...

Answer 6

It sounds like you got the 4.3" monitor Mount #LC776462 which has a smaller 0.6" ball. You will need the Mount #FR79SR which fits your larger 5" Monitor #FR97FR with a 0.85" diameter ball. This mount will stick to the window and…

view full answer...

Answer 7

The Replacement Furrion Monitor Power Cable #C-FOS07TAPK-006 you were already looking at is the correct replacement power cord for all Furrion Vision S camera system monitors.

view full answer...

Answer 8

Not at all, Ryan. The Meyer Base Line 240 #ME86FR and Base Line 400 #ME26FR tailgate spreaders slide right out of your 2" receiver - just pull the hitch pin, unplug the quick-connect wiring, and lift or roll them away. The 240 weighs around 95…

view full answer...

Answer 9

Hey Kevin, so the extra wire that is on the power wire #C-FOS07TAPK-006 is considered an auxiliary port. It's kind of goofy and random but if there was something you need powered that used that type of connector that's what it's for.

view full answer...

Answer 10

I spoke with my contact at Furrion and the barrel connector size of the Furrion RV Observation Camera System part #FOS05TASF is 2.5 mm x 5.5 mm.

view full answer...

Answer 11

The extra pigtail of the Replacement Furrion Monitor Power Cable part #C-FOS07TAPK-006 that you referenced is considered to be an auxiliary port. You could plug an additional accessory into it it as long as you have a matching connector.

view full answer...

Answer 12

Yes, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 55 Amp item #PD4655V is the correct replacement for the converter section of the Parallax model 7155. I have linked the installation instructions and a review video.

view full answer...

What is The Additional Power Cable Connector For On The Furrion Monitor Power Cable?

Product Page this Question was Asked From

Continue Researching