Which Curt Hitch for 2006 Honda Accord Sedan

Question

Question:

Hi, Im looking for a hitch for my 2006 Honda Accord EX v6 sedan. I saw there are 2 from Curt, C11327 and C11290. Can you tell me the differences? Thanks Dan

asked by: Daniel T

0

Expert Reply:

Hey Daniel, it is odd that Curt has two hitches that fit your 2006 Honda Accord. So since they have the same weight capacity as well as install time you'd want to go with the hitch that costs less because that's what I would do. So for that you'd want the part # C11290.

expert reply by: Jameson C

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 4

To answer the most basic part of this question first, you are correct that only Class I hitches with 1-1/4" receivers are available for your 2007 Honda Accord, but if your weight estimates are correct, they will be sufficient to handle this job.…

view full answer...

Answer 5

As long as your 2019 Mercedes-Benz Sprinter 2500 has a factory plugin connection point for the adapter part #3063-P you will not need to make any modifications to the adapter, it will plug right in into the factory plug and the other end to a…

view full answer...

Answer 6

Long story short you are going to need to buy a bike rack that is Class I 1-1/4 inch hitch compatible. The hitch adapters for going from a 1-1/4 inch hitch to a 2 inch hitch aren't going to fit a Class I hitch and the other thing is the adapters…

view full answer...

Answer 7

There are only so many different hitch designs for any given vehicle. For your 2007 Honda Accord the Draw-Tite hitch #24787 and Curt hitch #C11327 have the same basic design. This is because of where the best places are on the vehicle to attach a…

view full answer...

Answer 8

Hi JD; the Furrion Chill Cube #FR49TD air distribution box has a vent on it you can open and close. See the picture attached below. When it is closed it forces more of the air through the ducted system. Assuming you have a ducted system you will need…

view full answer...

Answer 9

Hey Trevor! I'm assuming you're asking if this setup will work with the Furrion Chill Cube #LC34DX. At this time, the only way to make it work would be to add in the air distribution box. This is possible, but it will also require a lot of…

view full answer...

Answer 10

Basically you are going to have to remove the lower vent assembly of your Dometic AC system and you'll see how it connects to the top portion of the system that mounts on the roof. Once the lower assembly is taken down you should see four bolt…

view full answer...

Which Curt Hitch for 2006 Honda Accord Sedan

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching