What is Diameter of Lock Core Side of B and W Coupler Lock part # BW23FR

Question

Question:

What’s the diameter of the key end of this lock?

asked by: Sylvia

0

Expert Reply:

Hey Sylvia, the diameter of the lock core side of the B and W Coupler Lock part # BW23FR is 1 inch.

expert reply by: Jameson C

0

Answer 1

I checked with B&W and their Trailer Hitch Receiver Lock for 3" Hitches item #BW23FR doesn't have a maximum capacity listed because it is rated for a shear strength much higher than the capacity of any 3" receiver and ball mount on…

view full answer...

Answer 2

Hello Oliver, thanks for reaching out. We can provide both the locks you mentioned, the Master Lock #1480DAT and #1469DAT, but I am sorry to say we do not offer a keyed-alike option for these. Both would come with a random key number. If you need a…

view full answer...

Answer 3

The Trailer Hitch Receiver Lock for 3" Hitches #BW23FR has a 5/8" diameter so it can be used for 2", 2-1/2", and 3" trailer hitch receivers. The 3-1/8" span makes it fit with up to 3" hitches though, which is why we…

view full answer...

Answer 4

Hey Don, welcome back! The Under-Bed Rail and Installation Kit #RP67KR for your 2024 F-350 matches the OEM prep package. You are not limited to Reese 5th wheel hitches. This can be used with the B&W Companion #BWRVK3300 and #BWRVK3305 or slider…

view full answer...

Answer 5

Hey William, so the 3 inch hitches do use the larger hitch pin diameter but the 2-1/2 inch hitches still use the smaller one. So with a reducer like the part #38735 technically you would use both sizes. If you check out the picture I attached you can…

view full answer...

Answer 6

Hello Jack, Great question! B&W does not have a specific weight rating for the Trailer Hitch Receiver Lock for 3" Hitches - Flush - 3-1/8" Span - Stainless Steel #BW23FR, they have it on their site that it works for Class III, IV, and V…

view full answer...

Answer 7

We do have bushings that are close to the 1-1/4 inch outer diameter, but not precisely. The Two Piece Nylon Bushing - Qty 4 #SP05-080 have a 1-5/16 inch outer diameter so it is very close, being 1/16 of an inch off. They do have the 9/16 inch inner…

view full answer...

Answer 8

Yes, if you wanted to determine what the pin weight of your trailer is you'd basically need to weigh the rear axle of your truck at a weigh station without the trailer connected and then connect the trailer and get the weight for the rear axle.…

view full answer...

What is Diameter of Lock Core Side of B and W Coupler Lock part # BW23FR

Product Page this Question was Asked From

Continue Researching