Towers for Yakima RoundBar on 2024 Honda CR-V Hybrid

Question

Question:

Im looking for your advice to attach an older version Thule Hullavator 897XT 2 sets to a 2024 Honda CRV Hybrid with roof rails no crossbars. I have done well with 48 inch Yakima round bars and Q Towers that clamped to the rails of a narrower 2009 Ford Escape. I own 58 inch and 76 inch yakima bars as well. I will need a way to extend the Hullavator far enough away from the sides of the Honda. Are there mounting towers for the Honda that would allow the use of the round bars? What would you recommend? Thank you

asked by: Jim F

0

Expert Reply:

There are towers available that will allow you to install your Yakima RoundBars on your 2024 CR-V Hybrid. You will need the following:

-SightLine Towers for Yakima Crossbars - Flush Side Rails - Qty 4 # Y64AR

-RoundBar SL Adapter for Yakima BaseLine, SkyLine, TimberLine, and RidgeLine Towers - Qty 4 # Y03536

-SightClip Fit Kit for Yakima SightLine and RidgeLine Roof Rack Towers # Y44UR

If you have Yakima Same Key System locks you can transfer them over or you can add new locks using # Y07204.

expert reply by: Robin H

0

Jim

3/27/2024

Thank you for your reply. Do you carry the parts to attach the Hullavator 897xt to the bars including the bar mount assembly and necessary hardware? Thank you, Jim

Robin H.

3/28/2024

@Jim the following parts should be everything you need to mount the old 897XT to your round bars: -Replacement Underbar Bracket for Thule Hullavator # TH8535860 -Replacement Pivot Pin for Thule Hullavator # 853-5869 -Replacement M6 x 22 Carriage Bolt # 915-0622-54 -Replacement M6 Washer # 951061254 -Replacement Round Nut for Thule Carriers # 853-5439

Jim

3/28/2024

@RobinH What about the Bar Mount Assembly, do you have those as well (part that the Hullavator attaches to). Thank you, Jim

Robin H.

3/28/2024

@Jim yes we do have the Replacement Bar Mount Assembly for Thule Hullavator # TH753352403.

Answer 1

The Thule Motion XT 22 cubic foot cargo box, part #TH629906 requires 55 inches of front clearance. To determine if it'll fit on your CX-5, you'll need to measure from the center of the front crossbar rearward until you reach the seam where…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hi Daniel; if you have the flush rails on your 2025 Honda CR-V you need the Fit Kit for Thule Evo Flush Rail and Edge Flush Rail Roof Rack Feet #TH52KE. If you don't have any rails, you need the Fit Kit for Thule Evo Clamp and Edge Clamp Roof…

view full answer...

Answer 5

Hi Deb! There are quite a few hitches available for your 2025 Honda CR-V Hybrid and I have the 2" receiver options (best size for what you are wanting) listed below with their corresponding weights. Curt Trailer Hitch Receiver - Custom Fit -…

view full answer...

Answer 6

There are indeed two 2" trailer hitches available for your 2020 Honda CR-V; the etrailer #e98848 and the Curt #C13397. These Class III hitches are essentially identical in every way except for the finish/powder coat that they use. I personally…

view full answer...

Answer 7

The available trailer hitches for your 2019 Honda CR-V can be pretty easily categorized into hidden and non-hidden groups. I highly recommend going with a hidden-crosstube hitch, especially on a new vehicle like yours, as this is going to create a…

view full answer...

Answer 8

Hey Rick, sorry about the confusion but the etrailer hitch part #e98848 that you referenced fits both the hybrid and non-hybrid versions of the 2025 Honda CR-V including your Sport model. It is organized in our fitguide in a somewhat confusing way…

view full answer...

Answer 9

Hi Rob, both the etrailer hitch part #e98848 and the EcoHitch part #EH25KR will install and function properly on your 2026 CR-V Hybrid Sport Touring, so you’re not risking choosing a hitch that won’t work. Both hitches use a hidden cross tube and…

view full answer...

Answer 10

Hey Dave, thanks for reaching out! The hitch I recommend picking up for your 2025 Honda CR-V Hybrid is the etrailer Trailer Hitch Receiver #e98848 because of the matte black finish. This not only looks better but it's also more durable than the…

view full answer...

Answer 11

If you check out the attached picture you can see it basically sits flush.

view full answer...

Answer 12

Hey Scott, thanks for reaching out! Yes, the Curt Trailer Hitch Receiver #C13397 will fit perfectly fine on your 2025 Honda CR-V Hybrid Sport. What are you planning on using the hitch receiver for?

view full answer...

Towers for Yakima RoundBar on 2024 Honda CR-V Hybrid

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching