Can The Ark Drop Down Corner RV Stabilizer Jacks Be Bolted On?

Question

Question:

can this be bolted on or only welded?

asked by: Rich

0

Expert Reply:

The Ark Drop Down Corner RV Stabilizer Jacks # AR34FR are designed to be welded on, so this is the only way we can recommend installing them. With the included mounts there really is not enough room between the stabilizer itself and the mounting plate to add any additional hardware. So, bolting them on is really not possible.

If you need a drop leg that can be bolted on, take a look at the Stallion Stabilizer Jacks # 288-01892-2 which are designed to be bolted on.

expert reply by: Jesse M

0

Answer 1

I have attached a few photos for you with all the dimensions we have for the Ark Drop Down Corner RV Stabilizer Jacks part #AR34FR. That said, Ark is an Australian company so the measurements are in metric, millimeter to be specific so you may need…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hi Ken! It looks like you have almost everything you need to set up your 2026 Jeep Gladiator Sahara for flat towing. The etrailer Invisible Base Plate Kit - Removable Arms #e98948 is a perfect fit and the etrailer XHD Non-Binding Tow Bar - RV Mount -…

view full answer...

Can The Ark Drop Down Corner RV Stabilizer Jacks Be Bolted On?

Product Page this Question was Asked From

Continue Researching