Recommended Replacement Motor For a Dometic Fan-Tastic Roof Vent

Question

Question:

I’m looking for a motor/gear housing part #k4017-09, can motor for an Atwood/Dometic rv ceiling exhaust fan. Any help would be appreciated

asked by: David O

0

Expert Reply:

Hey David, to replace your Dometic Fan-Tastic ceiling fan motor K4017-09, you can use the Replacement Fan Motor Assembly Kit for Dometic FanTastic Roof Vent Fans # FVK8017-00.

expert reply by: Bryce D

0

David O.

3/12/2024

Hi Bryce One of the phone reps at Domentic suggested that I could just replace the motor cover/cap, part #K6035-81. Would you have them in stock? Thanks

Bryce D.

3/13/2024

@DavidO We actually don't carry that part at all, unfortunately. I checked Dometic's website and I wasn't able to find them either, so maybe it's something that you'd need to order directly through them?

Answer 1

Hey Josh, the replacement for your existing B12EA-22 brake would be #AKEBRK-7R-SA for the right side and #AKEBRK-7L-SA for the left. There are two sizes of grease seals that fit 7k axles and there isn't a rhyme or reason as to which you may…

view full answer...

Answer 2

Yes, we do sell a replacement switch for the Fan-Tastic roof vent. The 3-Speed Switch for Fan-Tastic Vent Roof Vent item #FVK1031-05 replaces the 3-way switch in your vent.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Recommended Replacement Motor For a Dometic Fan-Tastic Roof Vent

Product Page this Question was Asked From

Continue Researching