Lionshead Bearcat Wheel Which Will Fit a ST235/80R16 Trailer Tire

Question

Question:

Im looking for an aluminum Bearcat wheel in black to use on a st23580r16 tire..I have a picture of what I have but cant tell if its black or gun metal gray..thx

asked by: John M

0

Expert Reply:

The Aluminum Bearcat Trailer Wheel # 274-000039 is currently the only size we carry in a 16" diameter. This is the Gunmetal gray color and has an 8 on 6-1/2" bolt pattern. It is also the correct width for a ST235/80R16 Radial Trailer Tire # TTWTRTM2358016E. As Lionshead is discontinuing a lot of their aluminum wheels you may only be able to find one in black used.

expert reply by: Bud M

0

John

3/4/2024

Ok thank you Bud..much appreciated sir

Bud M.

3/4/2024

@John You're Welcome.

John

3/5/2024

@BudM..hey bud..can you tell me the difference between the bearcat and bobcat aluminum wheel? I know the bearcat black isn't available and was thinking the bobcat would be a close match..thx in advance.

Bud M.

3/5/2024

@John The Bearcat # 274-000039 and Bobcat are going to be mostly cosmetic differences. While obviously the black on the Bobcat versus the gray of the Bearcat but the polished lip areas are different where you can see on the Bearcat the lugs are in the painted section while the Bobcat places the lugs in the polished raised lips. Both wheels are the same 16" x 6" size with 8 on 6-1/2" bolt pattern that accepts 1/2" or 9/16" wheel studs. The Bobcat has a slightly lighter capacity at 3,960lbs versus the Bearcat at 4,080lbs.

See All (7) Replies to John ∨

Answer 1

The correct replacement wheel you're after appears to be the Aluminum Bearcat Trailer Wheel part # 274-000039 which measures 16" diameter x 6" wide and has an 8 on 6-1/2" bolt pattern.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 4

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 10

The BTR and BT8 denotations refer to the spindle, not the trailer hub. The difference between a BTR and BT8 spindle is that the BTR spindle uses a 1.063" diameter L44649 bearing and the BT8 spindle uses a 0.99" diameter L44643 bearing. In…

view full answer...

Answer 11

Hey Clarence. There's no way to look at a tire or wheel and tell if it's a 5 on 4-1/2 or a 5 on 5 but you can take a real quick measurement to figure it out. If you'll look at the picture below you'll see a wheel with a red line on…

view full answer...

Answer 12

Great question, William! The Karrier ST225/75R15 #KE63KV is a KR35 while the Karrier ST225/75R15 #AM10303 is a KR03 according to Kenda. There is a slight variation in the tread pattern and from what Kenda says about them it looks like the KR03 is…

view full answer...

Lionshead Bearcat Wheel Which Will Fit a ST235/80R16 Trailer Tire

Products Featured in This Question

Continue Researching