Suspension Upgrade for a 2023 Subaru Ascent that's Sagging When Pulling a Trailer

Question

Question:

I have a 2023 Subaru Ascent and need to lift the back end up some with hitched to my trailer. What would your recommendations be?

asked by: Christine A

0

Expert Reply:

To keep your back end from squatting, I recommend the Coil SumoSprings Custom Helper Springs for Coil Spring Suspension item # CSS-1094R. These insert into your rear springs and keep your suspension from being pushed down by the weight of your trailer.

expert reply by: Jerred H

0

Chris

3/4/2024

Thank you for your assistance. I purchased the item you recommended and am waiting for them to arrive

Jerred H.

3/6/2024

@Chris You're welcome!

Answer 1

For your 2022 Subaru Outback Wilderness we have Thule roof racks that use aero shaped bars but since your vehicle has raised side rails the Aeroblade Edge rack you mentioned would not work. Instead a better option would be the Wingbar Evo Roof Rack…

view full answer...

Answer 2

Though it will ultimately depend on the loaded weight of the trailer you go with, the Blue Ox TrackPro #BLU36FR can be a great option. This is a weight distribution system that has sway control as well, but the big plus with this one is the weight…

view full answer...

Answer 3

The discontinued Thule Ascent 1700 Roof Mounted Black Cargo Box TH605 will have no issues fitting the OEM roof rack on your 2016 Subaru Outback Wagon, although you will need to measure for hatch clearance. If you have 26" or more from your rear…

view full answer...

Answer 4

It appears that the 2003 Jayco Kiwi 21C would have came with a #10 Dexter torsion axle. You can verify this if you still have an axle tag on one of your 2 axles or by measuring the bolt hole spread where the axle mounts to the frame. This should be…

view full answer...

Answer 5

Since the sticker on your trailer axle says Dexter Number 10 that means the lift kit part #K71-707-02 is a confirmed fit and would give you an additional 2-5/8 inches of lift. This is the biggest lift we offer for your trailer/axle setup. I attached…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 10

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 11

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Suspension Upgrade for a 2023 Subaru Ascent that's Sagging When Pulling a Trailer

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching