Replacement Air Conditioner Shroud For a Dometic Duo-Therm 630035.321 Rooftop Air Conditioner

Question

Question:

I need a replacement shroud for Duo Therm model number 630035.321. Dont see here on the website. Can you cross reference this number for a replacement shroud. Thanks

asked by: Tom R

0

Expert Reply:

The Replacement RV Air Conditioner Cover # AT3308046006 is the correct replacement for your Duo Therm 630035.321. Do note this cover is beige versus your current cover which is an eggshell white.

expert reply by: Bud M

0

Answer 1

The best way to confirm the presence and location of a brake controller installation port in your 2006 Holiday Rambler Ambassador is to provide the coach's VIN to the manufacturer so that they can confirm which model year of base chassis was used…

view full answer...

Answer 2

On some Holiday Ramblers the wiring port for a trailer brake controller can be found under the left side control panel next to the driver's seat. The four wires should be +12V (black), brake switch signal (red), brake output (blue) and ground…

view full answer...

Answer 3

For your Dometic DuoTherm the Advent Air Unit part #ACDOM150 would be your best option that will give you the higher BTU rating 15k and easily connects to the current wiring you have now.

view full answer...

Answer 4

You can replace your Dometic 630035.331 condenser units with the Advent Air Replacement RV Air Conditioner for Dometic Setup w/ Start Capacitor - 15,000 Btu #ACDOM150 you were looking at and still retain use of your current air distribution box and…

view full answer...

Answer 5

A brake controller like the Tekonsha P3 will work just fine with the air braking system on your motorhome. The controller will get its input from the brake stoplight switch, which tells it when the brakes are being applied. If there is a 7-way…

view full answer...

Answer 6

Yes, the Replacement Short Arm Assembly for RV Awnings part #LC404523 is correct for a Solera V000436372 Awning.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Replacement Air Conditioner Shroud For a Dometic Duo-Therm 630035.321 Rooftop Air Conditioner

Product Page this Question was Asked From

Continue Researching