Does Length of DeeMaxx Hydraulic Brake Hose # DE58GR Include Fittings

Question

Question:

Is the 60 in with or without the fittings? I would like to replace my 3x 64-in steel hose with these if the measurement is without the fittings included.

asked by: Dan M

1

Helpful Expert Reply:

The overall length of the DeeMaxx Hydraulic Brake Hose # DE58GR that you referenced of 60 inches does include the fittings. So the distance is from end to end.

expert reply by: Jameson C

1

Answer 1

Hey Ken, great question, and nice camper! The short answer is no you don’t rewire the Lippert ABS to work with the DeeMaxx kit, you essentially bypass it. Your Brinkley’s Lippert ABS controller is built for electric drum brakes, meaning it’s watching…

view full answer...

Answer 2

Great question, Matt, and you’ll be glad to know: no programming or special setup needed for the Electric Brake Assembly 12" ABS #LC83PX. These brake assemblies work just like standard electric brakes on your trailer’s wiring. One wire goes to…

view full answer...

Answer 3

Derek, great question, and you're definitely not alone in wondering this. The good news is, there’s no special programming required for the #LC73PX brake assemblies. They’re electric drum brakes, so they wire up just like any standard setup: one…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Does Length of DeeMaxx Hydraulic Brake Hose # DE58GR Include Fittings

Product Page this Question was Asked From

Continue Researching