Weight Distribution for a 2500 Pound Trailer with 320 Pounds Dry Tongue Weight
Updated 03/28/2014 | Published 03/27/2014 >
Products Featured in This Question
Question:
I have a 2008 Honda odyssey and want to tow a 2500 lb trailer with 320lb tongue weight dry - I expect to add up to 600lbs to the trailer - which weight distribution hitch with sway reduction would you recommend. Ideally i would like one with a little extra capacity as i intend to get a SUV as a next vehicle - is it possible to do this? Thanks for your help
asked by: Dirk H
Expert Reply:
Based on the weights you have provided it looks like the trailer tongue weight is about 13 percent of the gross trailer weight. If you were to add 600 pounds to the trailer than would bring the gross trailer weight to 3,100 pounds and the tongue weight to 403 pounds.
You will want to check your trailer hitch for the weight distribution capacities, if it is rated for it, and the vehicle owners manual to determine if it is rated for use with weight distribution. We have found in the past that certain Honda vehicles are not rated for weight distribution so finding that out first is important.
Some weight distribution systems have a tongue weight capacity range. You will want the tongue weight of the trailer, when loaded and ready to tow plus the weight of anything loaded behind the rear axle of the tow vehicle to be near the middle of the range.
So for example if the tongue weight is 403 pounds then a system rated for 200 to 600 pounds tongue weight would be perfect, # RP66082. This system comes with sway control and has the 200 to 600 pound tongue weight capacity range. The only thing you will need to add is a properly sized ball for the trailer coupler.
Use ball # A-90 if you need a 2 inch or # 19286 if you need a 2-5/16 inch. I have linked instructions for the weight distribution kit, an article on weight distribution, and an article on determining tongue weight.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Article: Determining Trailer Tongue Weight
- Shop: Trailer Wiring
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Trailer Hitch And Wiring Options On 2021 Chevrolet Traverse
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Q&A: Trailer Hitch Recommendation For 2020 Chevrolet Traverse To Carry Accessory
- Shop: Suspension Enhancement
- Shop: Air Lift LoadLifter 5000 Air Helper Springs - Rear Axle
- Video: DIY Install: Draw-Tite Max-Frame Trailer Hitch Receiver on your 2008 Ford Van
- Search Results: wdh
- Shop: Brake Controller
- Shop: Reese Weight Distribution - No Shank - Trunnion Bar - 6,000 lbs GTW, 600 lbs TW
- Shop: Towing Mirrors
- Shop: K-Source Snap & Zap Custom Towing Mirrors - Snap On - Driver and Passenger Side
- Video: TorkLift SuperHitch Everest Weight Distribution System Spec Review
- Search Results: 90160
- Search Results: 90885
- Search Results: shipping to canada
- Shop: Blue Ox SwayPro Weight Distribution w/ Sway Control for 2-1/2" Hitch - 20K GTW, 2K TW
- Shop: Vehicle Tow Bar Wiring
- Shop: Fifth Wheel Hitch
- Video: Set up: Curt Trailer Hitch Receiver on a 2021 Honda CR-V
- Search Results: c39hr
- Q&A: Recommended Electric Tongue Jack for a 6,000 Lb Travel Trailer
- Search Results: pro series weight distribution
- Search Results: 13397
- Q&A: Reese Weight Distribution Hitch # RP65509 for Towing Aliner Classic Pop-Up with 2012 Toyota RAV4
- Q&A: Recommended Weight Distribution Hitch for 3500-lbs Trailer

