How to Retighten the Awning Fabric On a Solera Powered Awning
Updated 08/28/2023 | Published 08/27/2023
Question:
Oh, I installed a brand new Solara power awning. When fully extended the fabric is droopy. I’m wondering if I can spin the awning tube to tighten this up? I had to the arms down and in this process I took the awning out of the arm, and perhaps do not roll it enough? I have pictures I couldSend. Thank you
asked by: Rita B
Expert Reply:
There are a couple of ways you can tighten the fabric on your awning. With the awning fully extended, you can dampen the awning fabric and let it dry out for about 15 minutes. This will cause the awning fabric to shrink back up a little bit and should return close to it's original form.
You can also check the screws on the rail that you would use to replace the fabric, and make sure that none of them have become loose to let some of the fabric out. You would need to pull the fabric back through the rail and re-tighten the screws.
Product Page this Question was Asked From
Replacement Air Spring for Firestone Ride-Rite Kit - Double Convoluted - Model 267C1.5
- Accessories and Parts
- Vehicle Suspension
- Springs
- Air Spring
- Double Convoluted
- 1/4 NPT
- Firestone
more information >
Continue Researching
- Video: A Closer Look at the Timken Bearing Kit for Lippert, Dexter, and AL-KO Axles
- Q&A: Replacement Hub and Drum Kit for a Lippert 3,500 lb Axle
- Q&A: Is There a Way to Tighten the Fabric and Fix the Tension on a Solera RV Awning?
- Q&A: Do Hub Races Have to Be Replaced Each Time Bearings Are Changed
- Q&A: Is There a Special Tool Or Trick To Installing Trailer Grease Cap On Trailer Hub?
- Q&A: Is There Trailer Bearing Kit With Bearings L44649 & L68149
- Q&A: Does Race Need To Be Replaced If Installing New Bearings
- Shop: Lippert Brake Drum and Hub Kit - 3,500 lb Axles - 10" Diameter - 5 on 4-1/2 - 1/2" Studs
- Shop: Timken Bearing Kit, L44643 Inner/Outer Bearings, L44610 Inner/Outer Races, 204507 Seal
- Shop: Trailer Wheel Center Cap Plug - Chrome
- Shop: Trailer Wheel Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: Dexter Bearing Kit for 4.4K Axles - Bearings LM67048/L68149, Races LM67010/L68111
- Shop: Dust Cap Driver Tool - Medium - for 2.440" OD Grease Caps
- Shop: Timken Bearing Kit for 3,500 lb Axles with #84 Spindle - Bearings L44649/L68149
- Q&A: Tips for Removing Races from a Trailer Hub and Drum Assembly
- Article: Trailer Wiring Diagrams
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Shop: Trailer Wiring
- Search Results: trailer tires and wheels
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Suspension Enhancement
- Video: Measuring To Choose The Right Trailer Axle
- Search Results: trailer wiring
- Video: etrailer VS Dexter Self Adjusting Brakes Comparison
- Shop: Brake Controller
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Search Results: trailer jack
on Accessories and Parts
