Is There a Way to Tighten the Fabric and Fix the Tension on a Solera RV Awning?
Published 11/07/2019 >
Question:
How do I manually adjust the tension on the fabric once it has began to sag?
asked by: R.schnell
Expert Reply:
I was able to reach out to my contact at Lippert, who manufacture the Solera awnings and they mentioned a few things that you could try to try to tighten up the fabric on your awning if it has been stretched out over time, but there isn't a way to manually adjust the tension on an awning like the # LCV000163279 .
In warm weather, with the awning fully extended, you can dampen the awning fabric and let it dry out for about 15 minutes; this will cause the awning fabric to shrink back up a little bit and should return close to its' original form. This would be the only option if you have a manually operated awning.
If you have a powered awning, you can also check the screws on the rail that you would use to replace the fabric on the awning and make sure that none of them have become loose and let some of the fabric out. You would need to pull the fabric back through the rail and re-tighten the screws.
Product Page this Question was Asked From
Solera RV Slide-Out Awning - 73" Wide - White
- RV Awnings
- Slide-Out Awnings
- Extends 4 Feet
- 6 Feet Wide
- 68 Inch Wide
- 69 Inch Wide
- 70 Inch Wide
- 71 Inch Wide
- 72 Inch Wide
- 73 Inch Wide
- White
- Solera
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: straight tongue trailer coupler
- Video: A Closer Look at the Timken Bearing Kit for Lippert, Dexter, and AL-KO Axles
- Q&A: Replacement Hub and Drum Kit for a Lippert 3,500 lb Axle
- Q&A: Does Race Need To Be Replaced If Installing New Bearings
- Q&A: Do Hub Races Have to Be Replaced Each Time Bearings Are Changed
- Q&A: Is There Trailer Bearing Kit With Bearings L44649 & L68149
- Q&A: How to Retighten the Awning Fabric On a Solera Powered Awning
- Q&A: Is There a Special Tool Or Trick To Installing Trailer Grease Cap On Trailer Hub?
- Shop: Timken Bearing Kit, 14125A / 25580 Bearings, 14276/25520 Races, 10-36 Seal
- Shop: Dust Cap Driver Tool - Small - for 1.986" Grease Caps
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Shop: Timken Bearing Kit, L44643 Inner/Outer Bearings, L44610 Inner/Outer Races, 204507 Seal
- Shop: Grease Seal - Double Lip - 2.125" ID - 3.376" OD - GS-2125DL
- Shop: Timken Replacement Bearing and Race Set - L68149 and L68111
- Shop: Dust Cap Driver Tool - Medium - for 2.440" OD Grease Caps
- Q&A: Replacement for 3,500 lb Lippert Axle With 85" Hub Face Measurement
- Shop: RV Exterior Lighting
- Video: All About the Replacement Drive Head Pin for Solera Power RV Awnings
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Shop: BOLT brand vehicle and hitch locks
- Video: The Low-Down on the Rubber Hollow Bulb Seal for RV Slide Out
- Search Results: camera
- Video: Detailed Breakdown of the Replacement Idler Head Pin for Solera RV Awnings
- Search Results: smartplug
- Article: Using a Portable Generator on RV
- Video: All About the Rubber Bulb Seal for RV Slide Out
- Search Results: 44649
- Shop: RV Mattress
- Search Results: curt trailer hitch
- Search Results: plumbing vent

