Replacement K/15 Bolt for Thule Xsporter Ladder Rack

Question

Question:

I need part K all 8 of them

asked by: Jose J

0

Expert Reply:

The replacement bolt for the Thule Xsporter part # TH500XT you are looking for is the part # TH28FK.

expert reply by: Jameson C

0

Answer 1

That is completely normal. Thule states that the Cantilever Extension #TH24002XT will sit about 1.5" to 2" higher than the bed racks. Once the rack system is properly loaded, it will level out with the height of the bed racks. If you are…

view full answer...

Answer 2

The crossbars on the Thule Xsporter ladder rack #TH500XT-XK4 just bolt onto the uprights so taking one off can be done with simple hand tools or powered drive tools. You could also lift the crossbar and 2 uprights off but that would require 2 people…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 5

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 6

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 7

Hello Joe, Thanks for writing in! Based on the measurements you provided, the Gen-Y Glyder Shock Absorbing Ball Mount #325-GH-12001 is not the right fit for your setup. Since your Tundra's receiver measures 18 inches from the ground and your TAB…

view full answer...

Answer 8

Hey Bryan, thanks for reaching out. We do offer the TracRac base rails for the 2016 Toyota Tundra long bed. Here is what you'll need: - Base Rails for Thule TracRac SR Sliding Truck Bed Ladder Racks #TH21011 What will you be using the ladder rack…

view full answer...

Answer 9

It sure is Doug and congrats on your new truck! The TruXedo Pro X15 Soft Tonneau Cover item #TX33TV has been confirmed to fit your new 2026 Ford Maverick. The TS Rails item #TH25FR are going to fit alongside the rails of the Pro X15 item #TX33TV on…

view full answer...

Answer 10

You sure can David! Two of the Yakima JayLow Kayak Roof Rack Carriers item #Y04073 require 58" - 60" of crossbar space for two 30" wide kayaks. The Malone AirFlow2 Roof Rack item #MAL84AR is 58" long so you'll have just enough…

view full answer...

Answer 11

Hey Howard, thanks for the information. The Malone AirFlow2 Roof Rack item #MAL74AR, you referenced, will indeed fit the raised roof rails on your 2024 Subaru Crosstrek WILDERNESS edition. These 50" long x 3" wide x 1" tall crossbars…

view full answer...

Answer 12

I'm sorry for the confusion Doug as this is a common issue with our fit guide with vehicles like your 2024 Subaru Outback. On the Malone AirFlow2 Roof Rack #MAL74AR you found we list both excluding Wilderness and Wilderness to say it will fit…

view full answer...

Replacement K/15 Bolt for Thule Xsporter Ladder Rack

Products Featured in This Question

Continue Researching