Is There A Solution For A Bent Or Broken Leg On A Lippert High-Speed Power Stabilizer Jack
Updated 05/10/2023 | Published 05/08/2023
Products Featured in This Question
Question:
in the answer to question regarding bent legs on the Lippert PSX1, you mention you have a solution.... what is that solution?
asked by: Derrick
Expert Reply:
The wording in that answer page is a bit confusing. Essentially the legs are not replaceable on their own and you'd have to completely replace the entire entire stabilizer # LC369774 with another one. Lippert unfortunately likes to make a lot of jacks that are completely trashed if one small component breaks.
If you would prefer to switch to a stabilizer that can also be used for leveling then you would need the Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors # UF39-941705 instead.
Product Page this Question was Asked From
Lippert High-Speed Power Stabilizer Jack - White Switch Kit - 30" Lift
- Camper Jacks
- 5th Wheel Camper
- RV Motorhome
- Travel Trailer
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 30 Inch Lift
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: furrion replacement monitor
- Search Results: furrion rv camera system
- Shop: Replacement Foot Assembly for Lippert Components Power Stabilizer Jacks - Qty 1
- Shop: MORryde StepAbove RV Steps for 23-3/4" to 26-1/4" Wide Doorways - 3 Steps
- Shop: Ultra-Fab Footplate for Landing Gear and Stabilizer Jacks - 8" x 5-3/4"
- Video: Let’s Check Out the Replacement Thumb Turn Cam Latch Cylinder
- Q&A: Can Bent Leg On Lippert High-Speed Power Stabilizer Jack Be Replaced
- Shop: Replacement Thumb Turn Cam Latch Cylinder - Stainless Steel - 1-3/4" Long
- Shop: Replacement Electric Stabilizer Jack Support Arm for Lippert RV Jack - Yellow - Qty 1
- Shop: Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors - 30" Lift - 6,000 lbs
- Shop: Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 5" Screen
- Q&A: Is There A Replacement Leg For Lippert Electric Stabilizer Jacks PSX1?
- Q&A: Using Larger Foot Plate on Lippert Stabilizer Jacks
- Q&A: Replacement Foot Pad for Lippert Stabilizer Jack 337199
- Q&A: Are Legs of Lippert Stabilizer Jack PSX1 Replaceable
- Q&A: Is There a Replacement Leg for the Lippert Stabilizer Jack 198641
- Q&A: Troubleshooting Lippert Stabilizer Jack that Was Bent and Leg No Longer Lowers