Replacement Spring Bar Retainers Compatible With Reese 49912 Weight Distribution Hitch

Question

Question:

Hello, Im looking for replacement trunnion clips to retain the bars on my Reese 49912 weight distribution hitch 8000lb round bar. I cant seem to find them easily. If you have them Id appreciate a link to purchase them.

asked by: Brandon P

0

Expert Reply:

While Reese does not offer replacement spring bar retainers for their Weight Distribution Hitch 49912 # RE94FR, I do know some have used the Curt Spring Bar Retainer # 17109 to replace them. These have a very similar design to hold the retainer pin in place.

expert reply by: Bud M

0

Answer 1

Hey Ron & Leslie, The Replacement Spring Bar Retention Bracket Kit #RP58498 you were looking at is a compatible replacement for your Reese Pro Round Bar Weight Distribution #RE34FR or you could also use part #RP25FR.

view full answer...

Answer 2

Yes, the Replacement Spring Bar Retention Bracket Kit #RP58498 will work for your Reese 49912 weight distribution system.

view full answer...

Answer 3

Yes, the Replacement Spring Bar Retention Bracket Kit #RP58498 can be used for your Reese Pro Round Bar Weight Distribution w Sway Control #RE44FR.

view full answer...

Answer 4

It sounds like you're looking for the spring bar retention bracket for your Reese Pro Round Bar Weight Distribution #RE94FR. The correct replacement is the Replacement Spring Bar Retention Bracket Kit #RP58498.

view full answer...

Answer 5

Hey Mike, so a friction sway control unit like the part #83660 can help stop some of the sway that starts from wind or passing semis but if you are experiencing persistent sway once you hit a certain speed that will only be fixed by increasing the…

view full answer...

Answer 6

The main reason for the price difference is the different construction used for the weight distribution hitches. The Reese Weight Distribution System #RP66540 uses mostly cast parts that are more expensive to manufacture. While the Reese Pro Round…

view full answer...

Answer 7

Yes, the Replacement Spring Bar Retention Bracket Kit #RP58498 is the correct L-bracket for the 49913 part #RE44FR.

view full answer...

Answer 8

It sounds as if you're needing the spring bar retainer clip kit. If you have the Curt or a Reese Round Bar system, use #17109 which includes 2 clips, 2 lock pins and two drive-in rivets. The exact kit needed will depend on which…

view full answer...

Answer 9

Reese does not offer the spring bar retainer clips like you have referenced. The really good news is that you can use either the Replacement Spring-Bar Release Clip #FA94-02-1059 or Curt #17109. These clips will work as replacements for the hitch you…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Replacement Spring Bar Retainers Compatible With Reese 49912 Weight Distribution Hitch

Products Featured in This Question

Continue Researching