How to Convert Progressive Dynamics 4000 Series Control Center to Lithium Battery

Question

Question:

I have an RV with a PD4000 Power Control Center and convention lead acid batteries. I am going to upgrade to LiFePo4 batteries. Do you have the 4000l Power Control Center or the upgraded converter component to be able to use the lithium ion batteries

asked by: Bill

0

Expert Reply:

For your 4000 Series Progressive Dynamics power control center the converter replacement you need so that it would be Lithium battery compatible is the part # PD4045CSV.

expert reply by: Jameson C

0

Answer 1

We do have an option for replacing your Elixir ELX-60. Unfortunately there is not going to be a direct replacement for the converter section. You will need to replace the entire panel with the Progressive Dynamics 4500 Series RV Converter…

view full answer...

Answer 2

Hey James, yes the Progressive Dynamics 4000 Series part #PD4060K would be correct to replace what you have now and does have a Lithium battery charge profile. You could definitely install this by yourself.

view full answer...

Answer 3

I went to the warehouse to double check and found that the #PD4045CSV does come with an LI/LA switch to allow you to charge lithium or lead acid batteries. Simply flip the switch from the LA setting to LI and you'll be ready to charge lithium…

view full answer...

Answer 4

Your Progressive Dynamics Panel part #PD4060K can be switched to Lithium mode pretty easily. If you check out the picture I attached you can see the circled selector that allows you to go between modes. You would want to have it moved to the LI…

view full answer...

Answer 5

Hello Will, thanks for reaching out. It may be possible to upgrade your tires, but the main thing to consider is the clearance in your wheel well area. You want at least 3" between the tire and the fender, and at least 1" between the inside…

view full answer...

Answer 6

Yes, we do have several options for an ST225/75-15 tire, load range D, on a 15 inch wheel with a 6 on 5-1/2 inch bolt pattern. We have the following options: #AM3S870 with regular steel wheel and bias ply tire #AM32664 with regular steel wheel and…

view full answer...

Answer 7

The 113/108 L is the load index which is normally translated to pounds capacity. For instance the 113 is 2,535 lbs maximum capacity and 108 is 2,205 lbs. For instance the Westlake ST205/75R14 Radial Trailer Tire - Load Range D #274-000012 has a…

view full answer...

Answer 8

The Taskmaster tire #TTWPRG235R16 and most of all special trailer tires are manufactured by a couple companies that are based in China. The tire must meet the same DOT specifications for tires to be sold in the USA.

view full answer...

Answer 9

I have included a picture showing how the motor and switch wire up on the Lippert stabilizer jack #LC298707.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

How to Convert Progressive Dynamics 4000 Series Control Center to Lithium Battery

Product Page this Question was Asked From

Continue Researching