Troubleshooting Opti-Brite Motion Activated LED Dome Lights That Won't Turn On

Question

Question:

Had a question I bought the motion lights and had installed them on a 53foot reefer. Once plugged in to battery 12 volts lights turned on and stayed in for 5 min or so after they shut off and will not turn on again

asked by: Jesse E

0

Expert Reply:

It sounds to me like there might be a blown fuse or just a lack of voltage causing your issues with the Opti-Brite 12V/24V LED Dome Light for Refrigerated Trucks and Trailers # ILL28CMB. These lights can operate on 7v to 30v DC power so I recommend first checking that you're getting at least 7 volts using a multimeter # PT89ZR at the lights.

Next you'll want to make sure that the ground wires are ran directly to the frame. A bad ground connection can cause all sorts of issues for electronics.

If you're getting enough power and the ground connection is good then there would be an internal issue with the lights and you would want to reach out to Optronics to get a warranty replacement.

expert reply by: Kevin C

0

Answer 1

Hi Curtis; unfortunately, the timer on the Opti-Brite 12V/24V LED Dome Light for Refrigerated Trucks and Trailers #ILL28CMPG is not adjustable.

view full answer...

Answer 2

I spoke with my contact at Optronics and they informed me that the Optronics light part #ILL28CMB will sense movement up to 6 feet away and will remain on until no movement is sensed for 2-1/2 minutes. The sensitivity and duration are not…

view full answer...

Answer 3

The Opti-Brite LED Dome Light #ILL28CMPG puts out white light. The raw lumen output is 1,400 lumen. The effective lumen output is 990 lumen.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Troubleshooting Opti-Brite Motion Activated LED Dome Lights That Won't Turn On

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching