How Does The Lippert Replacement Nason Hydraulic High Pressure Switch Wire Into The System
Updated 02/07/2023 | Published 02/06/2023
Question:
I have a question on the LC 142927 IS THERE 12v POWER GOING TO SILINOID AND IF IT IS 12V IS YELLOW 12V OR IS IT JUST A REFRANCE ISGNAL. i DONOT HAVE A PLUG ON COACH SIDE i HAVE TO FIND A PLUG FOR COACH SIDE OF WIREING TO PLUG. LOOKING AT SILINOID WITH PLUG RELEASE FACING DOWN WHAT PIN IS HOT OR DOES IT MATTER
asked by: JOHN K
Expert Reply:
The Lippert Replacement Nason Hydraulic High Pressure Switch with All Weather Connector # LC142927 has a plug-in style connector and wouldn't connect to a bare wire. If the connector was cut off the wiring and that's why you have bare wire then you would need to reach out to Lippert and get a new connector and determine which wire would go to what in the connector to install this sensor.
Product Page this Question was Asked From
Lippert Replacement Nason Hydraulic High Pressure Switch with All Weather Connector - 2,150 psi
- RV Slide Out Parts
- Controller Parts
- Hydraulic Parts
- Switch
- Lippert
more information >
Continue Researching
- Shop: Lippert Replacement Nason Hydraulic High Pressure Switch with All Weather Connector - 2,150 psi
- Search Results: pressure switch
- Shop: Replacement Lippert Touchpad for Kwikee Level Best Hydraulic Leveling System - Winnebago
- Q&A: Which Replacement Nason High Pressure Switch for Slideout System
- Q&A: Correct Replacement Pressure Switch for Lippert Level Up Hydraulic Leveling System
- Q&A: Troubleshooting Jacks Down Light On Lippert Level Up While Driving But Jacks Aren't Dropping
- Q&A: Hydraulic High Pressure Switch for Lippert Leveling System on 2006 Damon Challenger
- Q&A: What Is The Material MB Sturgis Propane Hoses Made Out Of
- Q&A: Troubleshooting Slide Out Creep With A Lippert Hydraulic Slide Out System
- Q&A: Can a 50 Amp Watchdog Surge Protector Be Used on a 30 Amp Hookup?