Frame Too Big for Frame Brackets for Curt TruTrack Weight Distribution System - 10"  

What you've been told is likely the culprit, and I don't believe that it's coming from an issue on the Curt #C56357 you've installed. I would check the ground wire on the trailer wiring harness to make sure that it is…

You have a short on the trailer wiring most likely between the 12 volt accessory circuit, the frame of the trailer, and the brake output circuit of the brake controller. You'll need to go over the wiring of the trailer looking for any…

We have confirmed that the cable of the Valterra waste valves like part #TC172 can be trimmed shorter. While we don't have a video that shows this process you'd need to cut the outer cable and inner cable before assembling the valve.…

I am not sure what the different wires on your Jayco Jay Flight 2077BHS are connected to but from my understanding the new water heater should be configured as follows: Blue - Lock Out Lamp Green - Ground Orange - Gas Control White - Electric Control…

Hi David, There is an option for bump stops for your 2024 Toyota Tundra with a 3-1/2 inch lift by using Timbrens, you'll just need a spacer kit and some extra spacers to go with it. So what you can use is the Timbren Suspension Enhancement System…

The B&W Continuum #BW78FR and the Reese Strait-Line #RP66083 are both great systems. The B&W Continuum is going to be easier to set up, but as far as sway control goes, I definitely have to give the edge to the Reese Strait-Line. The…

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

To select the correct B&W Continuum Weight Distribution System for your needs you will first need to determine if you have a standard coupler(mounts on top of trailer frame rails) or an underslung coupler(mounts on the bottom of the trailer frame…

The B&W Continuum Weight Distribution System part #BW78FR requires at least 24" of space on the frame directly behind the coupler and along the side a few inches back from there. This works with most trailers but for some it will not and,…