Is Roadmaster Sway Bar # RM73FR Adjustable

Question

Question:

Hi can the setting be adjusted like some other sway bar kits?

asked by: Chris S

0

Expert Reply:

The Roadmaster Rear Anti-Sway Bar # RM73FR does not have any adjustability but it is going to provide you with a huge improvement in handling and body roll reduction that you won't want to adjust any aspect of it.

expert reply by: Jameson C

0

Answer 1

The TorkLift StableLoad Suspension Upgrade w Quick-Disconnect #TLA7310S should fit just fine with the Air Lift air bag kit and RAS on your 2021 Ram 3500. My concern though is that you've either already worn out the factory suspension on your…

view full answer...

Answer 2

Rene, you unfortunately are not going to be able to use both air bags and SumoSprings like #SS68RR at the same time. The air bags fit inside the coil springs on the bag so there would not be room to also have the SumoSprings. Even if you were able to…

view full answer...

Answer 3

No, it won't and it's because of the exhaust. The Hellwig Big Wig Rear Anti-Sway Bar item #HE24MR will only work on the diesel models of the 2024 Ram 3500. It is not compatible with your 6.4 Hemi model. The Roadmaster Rear Anti-Sway Bar item…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Is Roadmaster Sway Bar # RM73FR Adjustable

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching