Does The Lock N Roll Articulating Trailer Hitch # 336VS501 Allow You To Reverse The Trailer?

Question

Question:

Can you back up with it like a ball hich?

asked by: Mike M

0

Expert Reply:

Yes, the Lock N Roll Articulating Trailer Hitch # 336VS501 will allow you to backup your trailer just like a traditional ball hitch. Since the hitch and Coupler # 336TS528 lock onto one another there is much less noise than you will get with a traditional ball coupler.

expert reply by: Bud M

0

Answer 1

Hi Todd, I do have a drill-powered A-frame jack for your enclosed trailer that meets all of your needs, and what I recommend for you is the Lippert Quick Drop Tongue Jack #LC733926. The #LC733926 just requires a 3/4" socket which you can use…

view full answer...

Answer 2

Welcome back Bob and thanks for the information. Like a standard ball mount the Lock N Roll Articulating Hitch item #336VS511 is not going to do anything to address trailer way. There are no weight distribution systems with built in sway control that…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Does The Lock N Roll Articulating Trailer Hitch # 336VS501 Allow You To Reverse The Trailer?

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching