Replacement Fan-Tastic Vent LF8000 For Travel Trailer

Question

Question:

What would be the correct replacement for the entire vent unit?

asked by: Joann

0

Expert Reply:

When it comes to replacing your Fan-Tastic Vent # LF8000 The Fan-Tastic Vent Roof Vent # FV803350 would work for you.

The fan has 3 manual speeds that lets you boost or reduce airflow as needed. It has Rain sensor that will signal the dome to close automatically and for the fan to shut up on when wet. The vent has a simple installation with a 2-wire design.

The Roof Vent Installation Kit # 344270KITW is needed for installation.

I attached a review video link below.

expert reply by: Noah E

0

Answer 1

Looks like the correct replacement vent lid you would need is the part #FVK1020-19. This is the correct replacement vent lid for Fantastic roof vents like your LF8000.

view full answer...

Answer 2

Hey Jon, thanks for the pictures and the information! To replace the fan and motor assembly on your FanTastic LF8000, you'll want the Replacement Fan Motor Assembly Kit for Fan-Tastic Vent Roof Vent Fans item #FVK8017-00. Did you have any…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 7

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 8

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 9

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 10

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Answer 11

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 12

Hey Aaron, since it's a Fan-Tastic roof vent the correct lid would be the part #FVK1020-19 that you referenced. They've only used the one roof vent lid design over the years.

view full answer...

Replacement Fan-Tastic Vent LF8000 For Travel Trailer

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching