What Are The Dimensions Of The Replacement Sidewind Handle Shaft Bushing?
Updated 08/22/2022 | Published 08/19/2022
Products Featured in This Question
Question:
Is the outside dia of the smaller part .75inch and the overall dia of the part 15/16?
asked by: Dan
Expert Reply:
I actually went out to our warehouse and measured the:
-Replacement Sidewind Handle Shaft Bushing for etrailer and Ram Square, Direct Weld Jacks # TJD-7000S-BU with a set of calipers # PTW80157, and measured:
-30.09 mm (1-3/16") for an overall diameter,
-23.02 mm (.91") for an overall diameter of the inner circle,
&
-21.64 mm (.85") for an overall diameter of the inner circle to the flat piece (shown in image).
I have attached a diagram depicting these measurements for you to check out as well.
(click to enlarge)
Product Page this Question was Asked From
Replacement Sidewind Handle Shaft Bushing for etrailer and Ram Square, Direct Weld Jacks - 7K
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Bushings
- etrailer
more information >
Continue Researching
- Shop: Brophy Swiveling D-Ring Anchors w Backing Plates and Hardware - Bolt-On - 2,000 lbs - Qty 4
- Search Results: hopkins 20099
- Shop: Brophy Swiveling D-Ring Anchor w Backing Plate and Hardware - Bolt-On - Recessed Mount - 2,000 lbs
- Video: Hands-On with the Replacement Bearing for etrailer and Ram Square Jacks
- Video: Review of etrailer Camper Jacks - Sidewind Handle Shaft Bushing - TJD-7000S-BU
- Search Results: bushing
- Shop: Replacement Sidewind Handle Shaft Bushing for etrailer and Ram Square, Direct Weld Jacks - 7K
- Q&A: What Are Dimensions Of Sidewind Handle Shaft Bushings For Direct Weld Jacks
- Shop: Replacement Sidewind Handle Assembly for etrailer and Ram Square, Direct Weld Jacks - 7,000 lbs
- Q&A: etrailer Square Jack w/ Footplate to Replace Ram Side Wind Jack
- Q&A: Replacement Bushing and Washer for Ram 8,000 lb Jack
- Shop: Replacement Miter Gear Kit for Dutton-Lainson Trailer Jacks - 600 - 1,000 lbs. (1997 and Newer)
- Shop: Replacement Bearing for etrailer and Ram Square Jacks - 7,000 lbs
- Shop: Replacement Washer Kit for Dutton-Lainson Trailer Jacks
- Search Results: jack handle
- Q&A: Replacement Parts for the Dutton-Lainson Sidewind Swivel Trailer Jack # DL22800
- Q&A: Pin Hole to End of Shaft Dimension for the Bulldog Replacement Jack Handle Part # BD500105
- Q&A: Are 800 lb and 1,500 lbs Replacement Fulton Trailer Jack Handles Interchangeable
- Q&A: Handle Diameter and Length to Fit etrailer.com Sidewind Jack Handle with Haul Master Trailer Jack
- Search Results: top wind jack
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer tires and wheels
- Shop: Trailer Wiring
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Suspension Enhancement
- Search Results: trailer jack
- Article: How to Measure Your Trailer Wheel Bolt Pattern
on Accessories and Parts
