PowerClick Mounting Hardware to Outside Edge Measurement for Thule Motion XT Rooftop Cargo Box
Updated 07/05/2022 | Published 07/03/2022 >
Question:
Hello, I am asking a somewhat obscure but important question to determine if the Thule Motion XT L 16 cubic foot #TH629707 will fit on my roof rack setup. I have done a lot of measuring and remeasuring, but specifically need to know what the distance from the furthest most external side edge of the roof box to the place where the PowerClick clamp mount begins. The best way to determine this would be to look at the bottom of the roof box and measure in from the furthest edge on the side to the point where the PowerClick clamp mount or slot would begin. My guess is that it would be 5 to 8 inches, but I need a very specific answer to determine if it will fit properly. I know it is a holiday weekend but if you are able to post an answer it would be much appreciated! Thanks for your assistance!
asked by: DH
Helpful Expert Reply:
From the slot for the PowerClick mounting hardware to the outside edge of the Thule Motion XT Rooftop Cargo Box # TH629707 is going to be 7" (see attached). I was able to confirm this with my contact at Thule.
Continue Researching
- Video: Easily Install Your Curt Trailer Hitch - 2026 Subaru Forester
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Shop: Curt Powered Tail Light Converter w/ 4-Way Flat Trailer Connector and Install Kit
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Comparing Thule AeroBlade Crossbars vs WingBar Evo Crossbars
- Q&A: Replacement Rubber Strip for Thule Aeroblade Bar SOA567X070
- Article: Trailer Wiring Diagrams
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Search Results: trailer hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Search Results: trailer wiring
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Suspension Enhancement
- Search Results: trailer tires and wheels
- Article: How to Choose the Right Trailer Hitch Class
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: trailer hitch ball mount
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Brake Controller
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Article: How to Measure for Trailer Hitch Drop
