Does The Air Lift LoadLifter 7500 XL Have An Internal Jounce Bumper?

Question

Question:

Please check this and confirm which one is it: have or not the jounce? Thank you.

asked by: Jose M

1

Helpful Expert Reply:

Yes, the Replacement Air Spring for Air Lift LoadLifter 7500 XL System # AL50236 does have an internal jounce bumper.

This air spring is a replacement hybrid spring for your Air Lift LoadLifter 7500 XL Air Helper Spring System, and is made in the USA.

I have also included a product overview video for you to check out as well.

expert reply by: Bryce D

1

Answer 1

Hey Steve, The AirLift airbags with internal jounce bumpers are not able to be added to a system without so you would need to get a whole new system. With that said the system with the internal jounce bumpers is going to create a much rougher ride…

view full answer...

Answer 2

Hey Brent, Good question and for your 2019 Ford F-350 4x4, I would go with the Air Lift LoadLifter 7500 XL Ultimate Air Helper Springs #AL57577. Compared to the Air Lift LoadLifter 5000 #AL57399, the the 7500 XL are going to give you the best…

view full answer...

Answer 3

The Firestone air bags do not have the jounce bumper that the Air Lift kits have. You want to always keep a minimum of 5 psi in the bags at all times, but at that minimum air pressure you still could bottom the suspension out in theory with enough…

view full answer...

Answer 4

I wish there was an easy solution I can recommend but Air Lift will void your warranty if you run lower than 5 psi in the bags and the compressor kit won't let you do that anyway. 5 psi SHOULDN'T make it unbearably stiff so I'd hate to…

view full answer...

Answer 5

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 6

Hey Don! The Pacbrake Alpha HD #PB32ZV you were looking at does not have the internal jounce bumper. You would need the Pacbrake Alpha HD Pro Air Bag Suspension w/ Internal Jounce Bumpers #PB92ZV. The jounce bumper adds additional support when…

view full answer...

Answer 7

Though the Air Lift LoadLifter 7500 XL Air Helper Springs #AL57541 and the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F2709 that are designed to fit your 2022 GMC Sierra 3500 are both American made and rated up to 7,500 pounds of…

view full answer...

Answer 8

The recommended PSI for The Air Lift LoadLifter 7500 XL Air Helper Springs - Rear Axle #AL57531 has a minimum recommended pressure of 5 PSI and a maximum air pressure of 100 PSI. I attached a review video link below.

view full answer...

Answer 9

Hello Luke, thanks for reaching out. Since you have an F-350 I do like the Load Lifter 7500 kit. The springs are going to be more robust and you will not need to add as much PSI to get the same level of support. Both the #AL55FJ and #AL86KV kits you…

view full answer...

Answer 10

The air bags that come in the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers #AL88204 has a 5" - 7" standard operating distance and the difference is just dependent on how much room you have available. So…

view full answer...

Answer 11

Hello Graham, thanks for reaching out. So far I have been pretty impressed with the PacBrake air bags. I would say they are in line with the quality of the Air Lift air bags. They use similar top plates. Pretty much everything about the design of…

view full answer...

Answer 12

Good question Griff! The Pacbrake Alpha HD Pro Air Bag Suspension Kit #PB89SV has their Internal Jounce Bumpers which means you technically can run them with 0 air pressure. However, I don't think I would do this as it would just leave those…

view full answer...

Does The Air Lift LoadLifter 7500 XL Have An Internal Jounce Bumper?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching