Recommended Trailer Hitch For My 1993 Chevrolet P30 Stepvan

Question

Question:

I have 93 chevy p30 stepvan that needs a hitch . Would the step be a problem for hitch installation? I have turned the truck into a food truck and need to pull my smoker.

asked by: James

0

Expert Reply:

I do have a solution for you, but it will not involve a custom fit trailer hitch. The Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide. part # 13703, is an adjustable universal hitch. It can fit frames from 22" to 72" in width. It comes with all the hardware you need to bolt it to your vehicle's frame, which requires drilling. It can also be welded to your frame. It has a maximum gross trailer weight of 3,500 lbs.

I have included a product description link and a video review link below.

expert reply by: Mark Smith

0

Answer 1

I went out to the warehouse and pulled Curt Class V Trailer Hitch #C15300 and took some measurements for you. From the front bolt hole to the rivet (center to center) is 1-5/16 inches. From the rivet to the rear bolt hole is 7-7/8 inches and the…

view full answer...

Answer 2

I spoke to my contacts at Curt and Reese and the only styles of hitches that can be made to fit a service body truck like yours are multi-fit hitches like the #41990 that has a 16k capacity. This is a weld on hitch that would require either the 7…

view full answer...

Answer 3

Hey Paul, thanks for reaching out! The bolt holes for the Draw-Tite Class V Trailer Hitch Receiver #DT45502 are spaced out 35-1/2" on center for the width, and then for the back to forth dimensions we're looking at 3-3/8" for the holes…

view full answer...

Answer 4

I definitely have a photo of the dimensions for the Curt Trailer Hitch Receiver #C15845! In the attached photo you'll see the spacing varies between 30" and 31" depending on which set of mounting holes you're looking at.

view full answer...

Answer 5

Assuming the 6-way connector on your motorhome was wired correctly, you should have one wire for running lights, one wire for the brake controller output, one wire for the right turn and brake, one for the left turn and brake, one for ground and the…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Recommended Trailer Hitch For My 1993 Chevrolet P30 Stepvan

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching