Can Demo Kar Kaddy X Tow Dolly be Reversed with Vehicle Loaded

Question

Question:

Does this dolly have a locking feature to aid reversing as I have heard it is almost impossible to reverse a car dolly without it?

asked by: Michael G

0

Expert Reply:

There is no feature on the Demco Kar Kaddy part # DM9713093 or any of the dollies we offer that would allow you to back up. If you were in a situation where you needed to back up you'd have to take the vehicle off the dolly.

expert reply by: Jameson C

0

Answer 1

It all has to do with the axle. The Demco Kar Kaddy SS item #DM9713045 has a steerable axle and the Demco Kar Kaddy X item #DM9713093 has a swivel platform. Both help with tracking behind your motorhome, however the steerable axle will be far…

view full answer...

Answer 2

The Demco Kar Kaddy X Tow Dolly part #DM9713093 has surge brakes so it only uses a 4-way trailer connector. Therefore, it would just simply plug into the motorhome without any additional components needed. The 4-way will transmit the lights from the…

view full answer...

Answer 3

Thanks for reaching out! The replacement brake pads for your Demco Kar Kaddy SS #DM9713045 can be found as part #DM59VR on our site. This includes parts for both sides of the tow dolly. If you want to replace the whole assembly then you can do so by…

view full answer...

Answer 4

I reached out to Demco and confirmed that the current replacement parts will work on your older 2003 Demco Kar Kaddy. You will need the following: -Replacement King Pin Bushing #DM73VR -Replacement King Pin #DM63VR -Replacement Hub Assembly #DM04369

view full answer...

Answer 5

Hello David, thanks for reaching out. The bearings for the Demco Kar Kaddy SS Tow Dolly #DM9713045 are sealed. So you cannot repack them. If the hubs are in need of replacement, you will need to replace the entire hub assembly with part #DM04369.…

view full answer...

Answer 6

The first thing to check is what the tow dolly manufacturer recommends for the tow dolly. Trailer tires, designated with an ST in front of the size, are built with a thicker sidewall to handle more vertical load. Your tow dolly certainly does have…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

Hey Kathryn, what specifically on the Blue Ox Alpha are you needing to replace? Unlike Roadmaster they don't have as many replacement parts but you can contact them about getting yours rebuilt but that's just not something we can help with.…

view full answer...

Answer 11

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Can Demo Kar Kaddy X Tow Dolly be Reversed with Vehicle Loaded

Continue Researching