Replacement Head Pivot Springs For Reese M5 5TH Wheel Trailer Hitch

Question

Question:

Can you get just the 2 springs for this Reese 32000 lb hitch?

asked by: Jack N

0

Expert Reply:

The Replacement Head Pivot Springs # 58229 are the springs you need for the Center Section # RP48FR of the Reese M5 5th Wheel Trailer Hitch # RP68FR.

expert reply by: Bud M

0

Answer 1

Usually, these springs should not have to be replaced unless they are damaged. You will want to check the Reese Replacement Spring, #30776, and make sure it is not damaged and check the Reese 16K Fifth Wheel Hitch, #RP30047, to make sure that there…

view full answer...

Answer 2

Hi Mark; your Ford 5th wheel hitch is the same as the Reese M5. The Replacement Head Pivot Springs #58229 are the correct replacement for your hitch. Any big plans with your 5th wheel this fall?

view full answer...

Answer 3

Hi Craig, What you're experiencing is a pretty common issue for a lot of hitches and it tends to be either a lubrication issue or just an issue with the angle that the truck and trailer are sitting at preventing the jaws from fully latching.…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

We have lift kits for trailer that easily add 2 inches to the height of the trailer. For that you'd want the part #RR23QX and you'd be set. I attached a picture that shows how it installs to give you an idea. This would be the easiest…

view full answer...

Answer 11

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 12

Louie, Yes, that is a great question. You do not have to worry about the air bags interfering with your B&W Turnoverball hitch setup. The Firestone Ride-Rite Air Bags with Easy Mount Compressor and In-Cab Control #F84XV are compatible with in-bed…

view full answer...

Replacement Head Pivot Springs For Reese M5 5TH Wheel Trailer Hitch

Product Page this Question was Asked From

Continue Researching