Replacement Circuit Board For MaxxFan Roof Vents w/ Exhaust Only Fan

Question

Question:

I am looking for a circuit board for a MaxxFan 10 speed fan with rain sensor and auto temp control. Exhaust only model

asked by: Jim

0

Expert Reply:

Since you have the exhaust only model the correct replacement circuit board is the Replacement Printed Circuit Board for MaxxAir Powered Lift RV Roof Vents w/ Exhaust Only Fan # MA39FR.

expert reply by: Robin H

0

Answer 1

Since multiple MaxxAir Fans have the same features that you listed it's honestly best to first determine the exact model number you have before purchasing anything and end up not having it be compatible. I've listed below all the available…

view full answer...

Answer 2

The correct Replacement Operator Mechanism for your model 4751KS MaxxAir MaxxFan is part #MA10-20281K-1AF. If your fan lid is unable to open even manually, then this is the part you need to replace. The other part you referenced, #MA10A04751KS would…

view full answer...

Answer 3

The 10C21275KEZ didn't come back to anything for me which means it's most likely already been replaced with a new version but I can't confirm which with just the part number. We typically just replace the circuit boards based on the model…

view full answer...

Answer 4

The 10B21275KE part #MA39FR replaces the 10-21275KE you mentioned as well so if you had an older model number you could use it in same application.

view full answer...

Answer 5

Yes, the Replacement Printed Circuit Board for MaxxAir Powered Lift RV Roof Vents w/ Exhaust Only Fan #MA39FR is the correct replacement circuit board for your 8501 model.

view full answer...

Answer 6

I did some checking and for the MaxxAir the correct replacement circuit board is the #MA39FR.

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Replacement Circuit Board For MaxxFan Roof Vents w/ Exhaust Only Fan

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching